Your cart is empty.
Your cart is empty.Product Description
120/240 Vac, 125 A, 1 Phases, 3-Wire Wiring, Main Lug Circuit Breake
- Series: eq, 120/240 vac, 125 a, 1 phases, 3-wire wiring, main lug circuit Breaker, plug-in, 4 spaces, 8 circuits, combination flush/surface cover, type 3R outdoor enclosure, 12-1/4 in overall height, 6 in overall width, 4-1/4 in overall depth, CSA Certified, UL listed. Code-gauge steel enclosure.
- Single phase, 3 wire, solid neutral, 4 spaces/8 circuits 1-pole, 2 Qp breakers 2-pole, 120/240 Volt AC. 10, 000 air. With closure plates.one piece plated aluminum bus bar. 100 percent circuit breaker twist outs. positive load side circuit breaker hook rail. suitable for use as service equipment when a main Breaker (100 amp maximum) is back-fed in a branch position and used with main breaker retainer clip No.MBR1.
- When used as service equipment, any unused neutral position may be used for equipment grounding. rotate entire device 180 degrees for bottom feed. gray enamel finish. csa and UL listed, complies fully with neck and UL requirements for class ctl. 6" x 12-1/4" x 4-1/4".
Customer
2025-08-14 16:08:16
The box is thin, the knock out is so clumsy. Would not recommend.
DRAR
2025-07-27 15:52:43
Knock outs are non standard…most likely metric or non US standard. Otherwise it’s good for the price. Perhaps the manufacturer could include some NM wire clamp connectors or various sizes.
bob
2025-07-17 09:21:27
Quality item. Well made
Charles Raybon
2025-07-08 12:21:15
Just the box I was looking for to distribute the power in my shed. Great little 4 circuit breaker panel.
Larry Jenkins
2025-06-03 15:36:24
This was not to the same standard as USA made. The thickness (gague) of metal used, cause a problem for the KO’s to be used. Selection of sizes jumped from .5†to 1.0 I needed .75†at bottom left and right side. I decided to drill out with multi-stage drill and the 1.0 popped out. I attempted to use KO punch instead of drilling the side and it popped out 1†Had to use plate from top hub blank, to cover hole and re-drill.Lost over an hour in labor to correct.The gasket required for Hub was way to thick, standard hub screws provided with Square D Hub were to short. It’s good I have to install 4- breakers, all breaker KO’s popped out when attempting to remove one. All due to the gauge of metal used.
db
2025-05-03 19:25:39
Great for my barn and a few circuits. Good quality.
Emily Brown
2025-03-17 11:40:55
There are three major things that make this sub-panel unsuitable for deployment.1) There is no ground bar2) The lug nuts for holding the line feeds AND neutral wires use Allen Wrench bolts/screws instead of standard flat head bolts/screws. That in itself is bad enough but to make matters worse they are three different sizes causing headaches for installation.3) Saved the dangerous part for last. The neutral bar snaps into cheaply made plastic that does not hold it properly in place. The natural bending or pressure from your wiring cause the neutral bar to pop out of the plastic holder and could easily come in contact with the surrounding box or worse yet, come in contact with your hot line leads.After trying to make a safe professional installation, I gave up and threw it away and purchased a higher quality panel.
Willard S.
2024-12-20 15:43:45
I'm installing it on an old boat and it was a great value a d it arrived as promised
Recommended Products