Shopping Cart

Your cart is empty.

Your cart is empty.

HoldRite 3/4 Inch ProGuard Stub-Out Clamp, PEX, PE-RT, Copper, CPVC, 732-H

4.9 (5) Write Review
Free shipping on orders over $29.99

$3.51

$ 1 .99 $1.99

In Stock

1.Size:1/2 In. Stub-out Clamp


About this item

  • COPPER: Stub-out clamp with Copper Tube Size rating
  • VERSATILE: Compatible with PEX, CPVC, or copper tubing
  • IDEAL: For fixture stub-out, lavatory/sink, toilet, tubing isolation, and vertical and horizontal applications
  • VERSATILE: Integrates with other HoldRite models
  • RATED: Meets UL 94 V-0 requirements


The HoldRite ProGuard Stub-Out Clamp provides rigid installation while maintaining an optimal outside bend radius. Transforming the plumbing industry through innovation. HoldRite: Converting Makeshift Methods into Engineered Solutions. The last three decades have seen HoldRite evolve from a single product family business to an international corporation and acknowledged industry leader. HoldRite has established a reputation as a leading manufacturer known for innovative products and services in such categories as pipe and equipment support systems, acoustical plumbing solutions, water heater accessories, and water and firestop sleeving systems.


Patrick Vernacchio
2025-09-03 13:16:12
Good product. Plenty of strength built-in to hold and bend PEX. I had to grind the fingers under the threaded collar to fit the pipe and tighten the collar.
R. Bruce
2025-08-02 10:52:58
These Holdrite products are great on the job! Difficult to find in stores here in Ohio and I don't know why. Thank goodness for the Internet.
Tag
2025-07-19 18:30:21
Recently installed 4 of these. Let me say that I absolutely love the concept and hate the implementation. After running the PEX through the hole the threads on the the expander are so far apart that I couldn't get the nut to catch. It would spin and spin no matter how much lateral force I applied. I'm ~6'4" and fairly strong and it just wasn't happening. After a quick prayer inspiration struck. I used pliers to snap off the bottom threaded tab. After this destructive modification the nut went on super easy.
Video misrepresents
2025-02-04 12:30:23
The video with the product does not show the same fitting. Luckily I can use the fitting by itself screwed to a stud.
The Grumpy Guy
2025-01-11 15:28:23
usually not one to give a rough review but this is so not worth the money even though it's not expensive it's definitely a waste of money and time there were better solutions out there for sure I'm not the person that would make any recommendations for because I don't use them that often But I know that there's definitely some better thing better out there than this waste of time waste the money will not recommend will not use again