Your cart is empty.
Your cart is empty.Holley 108-52 Base Gasket w/Studs
Jim P.
2025-08-27 18:33:15
Good item to get the carburetor a little higher off the manifold. Had to trim the front heat shield because of a pipe plug in the manifold, other than that a perfect fit. The mounting spacers are a good idea to keep from breaking the mounting tabs on the carb.
AAR
2025-07-18 10:20:22
Great gasket to get Carb.up off intake will help on heat carb will run a little cooler has a great seal to carb and intake good fit for my carbs on my 6 pack setup I like the gaskets and this is the best price I could find for this item
P. C. Menten
2025-07-16 14:53:52
A high quality part, packaged with correct studs. Recommended.
Dustin H
2025-06-18 19:41:05
Gasket seems like a nice piece, until you try to open the packaging... It may have just been a bad reseller or something who stored it improperly, but the packaging peeled the top layer of the gasket up with it. Absolutely ridiculous, and junk.
J Mac
2025-04-21 10:19:34
Fit like they said it would.
Theodore King
2025-01-22 14:23:00
Carb-to-spacer gasket, thick enough to provide resistance to heat-soaking. Three-ply yet seals as expected when following correct torque sequence. Center piece of gasket extends toward the front to protect the power valve and accelerator pump from heat coming off of the manifold.Would by again, keeping my current 2bbl is cheaper and easier than going to a 4bbl manifold at the time.As a note, the studs are short, far too short for my EGR application.
Megatron
2025-01-21 13:14:10
Worked as expected, nothing more nothing less
walter ignacio uribe zapata
2025-01-17 16:46:49
OK very well
Recommended Products
