Your cart is empty.
Your cart is empty.Product Description
- Heating and air conditioning are automotive luxuries that can be conveniently controlled as we cruise the roads. As time goes on, your fan loses power, fan settings become unresponsive, or you may even lose air flow in one or more of your ventilation outlets. These are all signs of a failing blower motor resistor, the component that controls power flow of your fan system.
- Signs of a Bad Heater Blower Motor Resistor
- 1. No air blowing through vehicle’s vents
- 2. Blower motor only working on high speed
- 3. Blower motor only working on low speed
- 4. The blower motor does not work under certain settings
- 5. Smoke coming out of the vents
- 6. Burning smell.
- 7. Fan won't turn off.
Feature:
- Design to control the fan speed in your AC and heating system
- Effectively Restore heating and cooling system to original peak performance
- Easy installation,Simply remove the screws, remove the resistor assembly, and install the new resistor in place
- Direct replace your original HVAC Fan Blower Motor Resistor and proper operation
- Reference OE Part Number:
- RU-353, 4864957, RU353, 2403-258461,RU1046,CR158
- Fits the following vehicles with MANUAL climate control ONLY:
- 1997-2001 Jeep Cherokee
- 1997-2006 Jeep Wrangler
- 1997-2001 Jeep TJ
lee guardiola
July 29, 2025
Great fit
Fausto Reynoso
July 7, 2025
Works out the box ! Easy to install and to use, direct replacement for the speed controller on my jeep
Debmickey
June 18, 2025
Worked Great to fix my blower in my Jeep
Errol M.
May 25, 2025
Worked great! Easy swap on my 2001 jeep Cherokee.
Travis James Swanger
May 16, 2025
The product felt like good quality, it was delivered in a fast manner, and it’s been doing its job ever sense. And great price point.
Phil
April 24, 2025
It works and fits.
John Call
April 18, 2025
When my '99 XJ's blower motor stopped on the lower settings, searching for possible causes was easy. But, once the part was identified, getting it the next day was even easier. The only difficulty was contorting myself to get the old resistor out and the new one installed. Four blower speeds came back. Thanks!
Mark Brown
February 10, 2025
My blower went out, so 1st, I bought the cheaper parts, this part, then the fan switch, and finally it ended up being the blower motor, all 3 parts are simple to install, if you haven't done it before, just watch a couple of videos
Recommended Products