Your cart is empty.
Your cart is empty.José
2025-06-03 11:07:12
El proveedor cumplió 100%
mattman
2025-05-28 15:50:33
Cons:The description of this is pretty bad.The description says the following:"3.â˜ã€Safety Guarantee】The power of the paint booth heater lamp is 3000W, 110V, and the automatic safety overload is for safety guarantee. This heating lamp will not release hot air and secondary pollution, which is very convenient and safe."I don't know what 'automatic safety overload' they're talking about, but there isn't one, unless you count your breaker panel... This comes with three IR lamp tubes that get wired directly to whatever cord you provide. There is no built in safety overload."5.â˜ã€Easy to Install and Operate】This paint curing lamp comes with a rotating lampshade and a stable adjustable metal tube structure, ball bearing rollers with the parking brake, very convenient and safe."This is the opposite of 'Easy to Install and Operate'. First of all, there are zero directions. That being said, if you have any experience wiring simple devices, this wont be tricky. If not, stay away from this.With all three IR tubes wired, this pulls 25 amps. That's a lot.You need to make sure whatever cord you use to wire this is rated for that. If you're going to use all three IR lamps, your wire or extension cord should be at least 10gauge.You also need to make sure whatever outlet(and breaker) your plugging this into is rated for 30amps.I'm only going to use two of the lamps with my setup. I'll leave the center lamp disconnected.With only two lamps connected, I can use a 20amp outlet with 12 gauge wire.Pros:It's fairly inexpensive and powerful. When you plug it in, it's on and hot. There is no warm up period. I'm not sure if this is a good thing or bad thing for the life of the IR tubes though.It did come with an extra IR tube, which was nice.I would only recommend this to someone who knows what they're doing when it comes to electricity and is in a commercial environment. This isn't for a hobbyist or a home garage shop, unless you're setup is well above average and you really know what you're doing.
Loran Atkins
2025-05-20 15:38:39
Very misleading there was no kinda instructions on how to assemble it at all and after that there was no way of knowing how to wire it at all! Furthermore I looked up a video and when I went to plug it in it melted my outlet and threw big sparks! I am almost sure the lights aren’t any good now! I am requesting my money back!
mario aviles
2025-03-25 10:26:07
Esta bueno coloque 6 de estas en caseta de pintura
Sujata Seesurrun
2025-01-01 13:44:05
No instructions, no power cord. Had no clue how to operate this. Misleading description
Recommended Products