Your cart is empty.
Your cart is empty.Product Description
Hydraulic Brake Park Lock
- Fit for cars, trucks, Disc or Drum brakes.
- Adopted materials that meet strict requirements, high reliability.
- Professional manufacturing, high accuracy and stable performance.
- This brake lock using hydraulic line pressure hold your brakes.
- Come with one extra sealing ring for replacement.
- Come with installation instruction for easier using.
Dimensions (length * width * height):
5.2 * 2.6 * 7.2cm / 0.08 * 0.17 * 0.24in
Specification:
- Condition: 100% Brand New
- Material: Iron
- Main Color: Black
- Package Weight: Approx. 176g
- Fitment: Fit for cars, trucks, Disc or Drum brakes.
- Package Included: 1 * Brake Lock
Operation:
1. Step on the brakes.
2. Push down the knob on the Brake Lock.
3. Release the foot brake and it's locked.
4. To release the lock, step on the foot brake and it opens automatically.
Install:
1. Use two holes to mount the brake lock where is properly.
2. In port (1/8in NPT): connect to master brake cylinder, it also come with 3/16in brake line fitting, you can chose to use the fitting or not.
3. Out port (1/8in NPT): connect to rear brakes, it also come with 3/16in brake line fitting, you can chose to use the fitting or not.
Note:
1. It should NOT be used under unintended, emergency or long time hold brake.
2. Please allow 0.5-1 inch difference due to manual measurement. (1 inch=2.54cm)
daniel brandon
2025-08-28 18:05:23
After getting this installed on the rear brake line and testing with the engine off it seemed to do the job.But, after the engine was running right off the bat it started leaking around the knob nut.Ok, so I tightened the nut down. it was very loose to begin with. Great, it seems to work.On the first incline that I needed to keep brakes on I set the brake lock. The knob wasn't very decernable if it was set or not. After letting off the brake pedal I could tell it was holding the rear brakes. Great.After having done what I needed to and was ready to get moving again I attempted to release the brake lock without pressing the pedal. This is a manual dump truck and don't want to roll down the hill backwards while getting going. It didn't seem to release by pulling on the knob while not pressing the brake pedal.So, as it was stated, I pressed down on the brake pedal and every bit of the brake fluid shot out around the knob!It had started to leak around the knob shaft this time. After this I could not press down on the pedal any harder than a feather or brake fluid would squirt out of the spring area.TLDR: Loose assembly, seals cannot hold pressure of brake system causing complete loss of brakes.
Tabatha Ludwig
2025-08-24 15:13:39
Was as describe, good quality.
KEN LEET
2025-07-17 15:45:15
These are very attractive for the price ... But not up to the task... Installed ,bled the brakes.. instant leak out the top of the valves .. not a big deal they do come with new o rings .. changed them out.. still leaked .. seems to be a machining flaw in them.. took apart my J mar valves.. they are double o ringed.. these are just not up to the task..
Chris nott
2025-06-13 12:18:32
Not that great
Rina Buchanan )
2025-06-11 11:12:29
Installed it in a customers truck. Works pretty good for a cheaper version
Joseph yardley
2025-04-12 13:14:13
I'd give it negative stars if possible. Need a good manual solution and this is not it. Go buy yourself a ball valve instead. I got the first one installed it and added fluid. Went to bleed the system and immediately stared pouring out of the center "shaft" area. I quickly had to un-install the rather difficult installation process and was left with no brakes. Until I received the replacement. Same process and it leaked just the same. Took it apart to find the oring has no chance in sealing into the bore that was drilled to big. Extremely disappointed that I had to do this twice each time having an immediate leak with a mess to clean up. Out the vehicle to drive to work and also out lots of money on brake fluid. Package even say QC pass which is a big NOT. please don't buy. Save your money frustration or you can read this after its too late and you went through it also.
Tim
2025-04-07 15:36:18
If I could give zero stars I would. Only a less than 30 day return window and my mechanic couldn't get it installed in that timeframe. As soon as it was installed the valve leaked. Totally worthless and a wast of money.
Wesley B.
2025-04-03 10:16:25
Leaks profusely around the stem, what a waste of time and materials for it not to work, not to mention the installation holes in my sheet metal. Terrible service, shame on Amazon for letting these guys sell this junk! The price is going down so the can sell out!
José L Gómez E
2025-03-31 11:08:28
Buenas tardesSe instaló pero no funciona, bloquea solo una llanta etcQuedó atena a sus comentariosGracias
Alex holt
2025-01-23 15:06:10
Faulty 2x
Lorne
2025-01-16 13:20:19
The park brake is a peace of ?????? Such a let down after drilling holes and making mounts and making lines the junk failed to work pissed brake fluid out the top I pulled it apart and found bad o ring replaced it it failed after one try need less to say I smashed the peace with a hammer will never buy anything from that company again so pissed does not deserve a rating
gilles demers
2025-01-15 16:04:15
produit sans qu'aliter
All round property care
2024-12-01 10:24:04
I installed this product and at least break fluid immediately I perceived the tighten it up and when I went down the road with my vehicle I lost all brakes all breaks could have killed me I want a refund and replacement or something I want a better product this is junk do not buy this
Recommended Products
$45.58
$ 22 .99 $22.99