Your cart is empty.
Your cart is empty.Product Description
Crafted From High-Quality Aluminum, Robbor Jack Pads Are Built To Last. Equipped With Two Rare Earth Magnets, They Securely Attach To Your Vehicle's Pinch Weld, Offering Superior Stability and Allowing You to Safely Lift Your Car From The Bottom, Just Like The Stock Jack.
Robbor Jack Pad is Made of Aircraft Grade Billet Aluminum with a Orange Anodized Coating, Effectively Protected your Vehicle.
Special Groove Design Ensures Robbor Pinch Weld Jack Pad Can Accurately Insert Into The Jack's Slot Or Other Structures, Providing A Firm And Secure Support For Lifting Operations.
The Premium Magnetic Jack Pads Are Made To Be Used With A Floor Jack With A Flat Top And Lift The Car Up By The Pinch Weld. Which can Prevent Your Frame Rails From Bending When Using A Jack To Lift Your Car.
PeterG
2025-08-01 10:08:36
I've used rubber spacers before to help with the seam weld when lifting car but this is much better.. does same job but doesn't fall off.. the magnets help it stay in place so I don' t have to hold it and pinch my fingers.
Robert and Linda Ballard
2025-07-08 13:17:01
This product works well and fits all of my vehicles. I bought an extra because the last time I used it I forgot to remove. The magnets work well to hold in place but not good enough to drive around and stay in place when I remeber to retreive. Won't make that mistake again.
Customer #66
2025-06-10 13:10:26
I tried this out on my '00 Integra.I have the OEM upgraded sideskirts, so they hang down a bit making the jack points a little difficult.These pop right on and stick in place with the magnets. Now you have an easy target to hit with the jack that is well below the sideskirts.The only thing that makes be a bit nervous is that the fronts hit the magnets & mounting surface at the same time the upper walls hit the body pan. A git of give and we're making marks in the body pan.Though the fact that the magnets get right on it to engage and hold it in place is a good sign.The rears don't have this issue, PLENTY of room.The thing to measure is your jack's cup. These are 2.75".That is swallowed by my Harbor Freight 3 ton high-lift, low-pro rapid jack. So, it works just fine.But my 2¼ ton Craftsman jack that I originally bought for the Integra when I was much younger is a no go.So, it depends on what you're working with.Measure twice, buy once.
6xagrampa
2025-04-29 11:49:48
These work like a charm! No more worrying about bending the narrow metal under the vehicle, no more worrying about the jack slipping off the frame! EVERYONE needs these if they're working underneath vehicles.
Capt;'n Jon
2025-04-05 13:50:43
I haven’t used it with my floor jack yet, but I did check to see if it fits into the pinch weld of my vehicle. and it did perfectly.
Albaraa Abu-Amara
2025-03-08 15:03:04
I've been using this product for a few months now and it's a really neat thing to have since jacking from pinch welds tend to cause the welds to deform and roll back, recently both magnets fell out and it made it much more of a hassle lining it up.
Martin
2025-02-25 15:43:30
This piece broke on first use
Ed
2025-02-05 16:16:27
Excellent product I should’ve bought it sooner. Thank you very much.
Recommended Products
$13.99
$ 6 .99 $6.99