Your cart is empty.
Your cart is empty.
-Type: Tapered angle Ball Nose End Mill / Cone Cutters
-Flutes: 2 Flutes
-Tip Radius: 1.0mm
-Shank Diameter: 1/4"((d1)
-Cutting Length: 1-1/4"(L1)
-Overall Length: 3"(L)
-Single side angle B=3.92°(Approx.)
-Coating: TiAIN
-Material: imported tungsten carbide
-Suitable For:Cutting, end milling, slotting on: aluminum, solid wood,partical board,Hard wood, plywood, etc; -Use top quality imported tungsten steel carbide -Excellent chip removal effect! -High surface finish, excellent work -Long service life
Also we have other tip radius tapered endmills:
R=0.25x1/4” shank ASIN: B01EMH3846
R=0.75x1/4” shank ASIN: B01EMJKIBU
R=1.5x1/4” shank ASIN: B01EVECZGM
R=2.0x1/4” shank ASIN: B01EVENNMM
MichaelR
August 18, 2025
These are great bits that remain sharp for a long long time (carbide is great). They are solid and do not break. I use them on a CNC machine where I need small bits and these work great. I have bought several and been very pleased.
john pattinson
August 11, 2025
Completed several carvings so far and the quality achieved is stunning, I hit a hold down screw with a previous one of these and although it still cuts to an acceptable level K decided to have a couple of the same to keep the quality work going
Ed Wan
July 27, 2025
Very nice tool. I ordered just one for evaluation. Quality seems good, delivery was very, very slow.
James L.Davis
July 6, 2025
This bit saves me hours of machine time.Before purchasing this item,I was doing roughing cuts with a 1/4†ball mill.Now, I just do finishing cuts.It gives a good finish with 20% step over.15% is better.
Charles Darwin
May 9, 2025
This tool works great for either rough and/or finish carving. Time will tell how long it stays sharp, but so far, it performed a 3 hour long carve just fine.
Eugene F.
March 28, 2025
Should have checked the length in the description. I'll keep it anyway for when I decide to upgrade to a larger CNC. Seems to be of good quality. Wll made.
Hiren Patel
January 27, 2025
This bit is amazing😇. I love how sharp it is, it works perfectly on my cnc machine without leaving any fuzz on the top of wood/ plastic.
hthoganfab
November 26, 2024
Works as expected on my CNC Router
Recommended Products
$29.50
$ 12 .99 $12.99