Your cart is empty.
Your cart is empty. KICKER brass hardware uses Versa-Gauge connection points with oversized convex screws for rock-solid connections. Use multiple gauge wires with no adapters needed. You get a clean, sharp install that lasts for years.
FHD AFS Fuse Holder, 1/0-8AWG in/out, Dual Fuse
The KICKER FHD Dual Fuse Holder accepts 1/0 – 8 AWG power cables and accommodates any size AFS fuse.
The wire receptacles work with most wire sizes for a clean, sharp install and a negative-post adapter collar that locks into place for a tight grip.
Charlie
2025-08-23 11:16:56
This works great for a car audio install where you would have two amps or in my case 1 amp and a hotwired fuel pump. On my Supra I ran a short piece of 0/1 gauge wire to this kicker splitter. From there I ran 4 gauge wire to under the passenger seat for my amp and then another 4 gauge wire to my hatch area for my fuel pumps. This allows for a clean install without trying to bolt multiple wires to your positive battery terminal. When installing it I mounted it to a piece of aluminum that I drilled and tapped for small screw bolts vs using zip ties.
Kayla
2025-08-06 11:44:35
It’s kicking
Steve H
2025-02-15 10:32:52
I don't understand why u wouldn't take 1 sec & stick a clear protector on the fuse cover ? They show 2 zip-ties in the pic but none in my boxes & u really need them unless u do some trimming & fitting on your own. The covers don't lock on & they're scratched up & rubbed dull from rubbing inside of the package. Pretty sad coming from a company that's been around a long as they have.
Jorge Ortiz
2025-01-20 13:33:04
If you’re building a car audio system
Recommended Products
