Your cart is empty.
Your cart is empty.Product Description
Vehicle Applications
- Ignition Knock Detonation Sensor
- Compatible with Acura :
- RDX 2007 2008 2009 2010 2011 2012
- RSX 2002 2003 2004 2005 2006
- TSX 2004 2005 2006 2007 2008
joe
2025-08-20 15:18:48
For the price I am so happy felt like the original in weight and size. Good quality and works perfectly. I was skeptical at first because the forms said to run OEM, but I took a gamble as it’s an older vehicle but 4000 miles and counting so far and no check engine light and my fuel economy went up as well. Don’t listen to the 1 star reviews this will work perfectly. Don’t listen to the Honda forms. You don’t need to remove your intake manifold get an 8 inch extension with a 27 mm socket and a long pair of needle nose and you can get it without removing your intake manifold you’re gonna go under it.
spasmatic
2025-08-10 17:59:41
good fit and worked as expected
Nigel McMulligan
2025-07-11 18:36:16
Put it in a couple days ago from below the CRV. Easy install—don’t over tighten. Clear engine light with OBD2 scanner when done. It was a quick job. Tools needed—trim tools, ramps, a 27mm wrench, and about a half hour. Good fit and value.
nolis
2025-06-10 17:34:55
Great price
Kai Sadler
2025-05-22 16:01:50
Lesson learned: I’m never buying car parts off Amazon again🙄This part broke off in my engine just from tightening it by hand. Cheap price for cheaply made garbage!!!
Jimmy
2025-05-08 20:15:26
Installed and reset the check engine light, it’s been fine since installed.Good for its price.
M. H.
2025-04-24 18:05:55
Sensor works well, and has been working well for the past week. Its critical on this sensor that it is torqued to the correct spec for a proper reading. This can be difficult to do depending on the vehicle. For a 2nd gen CR-V, it's impossible to get a proper torque value from the bottom. That means, that in order to obtain the proper torque of 23 ft/lbs, you would need to at minimum remove the starter. Even then it may be tight so intake manifold removal recommended. 23 ft/lbs is a low spec and easily overdone beings that you must use 1/2" drive tools, or a large box wrench, to remove and install this sensor.
T1John
2025-04-18 16:49:38
Fit like it should.
Junie
2025-03-20 13:26:09
Nice
Eduardo Luzuriaga
2025-03-07 10:45:11
Excelente reemplazo de la pieza original para una 2004 Honda CRV EX. Recomendable.
Hnda CRV 2003
2025-02-18 15:11:19
Working for 3 weeks so far....
David Cardenas
2025-02-17 17:30:01
Muy frágil se quebró apenas se instaló
Melke seiferaw
2025-02-14 18:40:14
Hi 👋
Recommended Products
$18.99
$ 9 .99 $9.99