Your cart is empty.
Your cart is empty.A & E HAND TOOLS - Ford Navistar 7.3 Turbo Direct Injection Adapter (TU15-22A)
thoai cao
2025-08-26 13:14:31
Its good quality.
Will S.
2025-08-15 18:59:27
If you have the option, which I didn't at the time of ordering because it wasn't in stock anywhere, spend the extra and get the OTC adapter. This was a pain to get threaded in to every hole trying to get around the rocker and injector hold down. I had the OTC one but went on walkabout and wasn't available when I needed to do a compression test, I had to grind the crimp for it to work and loosen and re tighten the injector hold downs and was still a hassle to use this adapter especially when I had used the OTC adapter which a thousand times easier to thread into the glow plug hole. It worked but it sucked to use. And I did get a die to chase the threads before even attempting to use.
AMBER Sonnenburg
2025-08-04 14:45:52
As other reviews had warned the threads could be a little sloppy I was prepared with a thread chase. I tried it first to no avail chased the threads and it works great.
Cody Gilbert
2025-06-01 15:43:53
This did not work at all. Threads are wrong wont thread into glow plug hole.
Paula Haglund
2025-05-07 17:45:34
The tool worked as designed and am happy with purchase
TJ
2025-05-03 18:08:11
Threads are tight as some others mentioned but I did not have to run them through a die and the coating is still on them. I threaded it in by hand and snug against the o-ring, and the hose is flexible enough to get around the rocker arms. The very tip of the "glow plug" has a Schrader valve for capturing accurate data. I used this with the Lang Tools TU-15 diesel tester without issue but the quick disconnect does seem a bit different.
Spencer Tainter
2025-04-08 15:23:18
Had to clean the threads with a die to get it to thread in
Customer
2025-04-03 13:13:28
If you're going to buy this make sure you buy a M10 1.0 mm die. It is impossible to thread in without fixing the threads first. You will waste your time trying!
Garrett
2025-01-17 11:57:26
Buy a m10x1.0 die and re cut the threads
Recommended Products
