Your cart is empty.
Your cart is empty.Product Description
All in one LED design: tail light, brake light, license plate light.
Easy Install, upgrade your tail light!
Upgrade your lighting
MOVOTOR tail light is low profile design, replace the bulky and ugly stock tail light, Lay Down Style, which is angled to follow the curve of your rear fender for the streamline look.
Package
1 piece of MOVOTOR LED Tail Light
1 Set of Screws
Mark Hopkins
2025-09-03 15:03:29
Installed this on my 2005 XR650L, super easy. Super Bright Light! I used lock nuts in place of the nuts that were supplied so I didn't have to over tighten them. I Also clipped the wires down to ~2-3 inches and crimped on new bullets so I could tuck the connections under the light.
Thieman W.
2025-08-26 13:10:48
I feel way better riding at night with this light installed as it’s much easier to see me on the road.
John
2025-08-19 16:40:31
The media could not be loaded.
Matthew Raymond devaughn
2025-08-10 14:07:39
Product fitment is very nice. Instructions included are detailed and useful. This tail light looks great, functions good, is Very bright and even has a tag light. Tested in the rain and still works perfectly. Better than other alternatives in my opinion.
Engine Shop Joe
2025-07-08 10:55:02
If you are leaving your stock fender on the bike this does not bolt up to it. The stock rear fender has a recess designed in it that the oem tail light fits into. There is no place to bolt it on that fender where it sits flat and looks good. On my 2023 DR the harness on this tail light will have to be extended as it is too short to reach the OEM plugs for the wiring. If you want it to look good you will need an aftermarket rear fender for light bolt up and you will need to do some wiring. It is not plug and play on the oem 2023 DR-650. It is a very bright light and I love that about it. It also looks water proof by design.
Selaretus
2025-06-12 18:44:43
Easy install, but it requires cutting existing OEM tail light wiring. New light wiring comes with three male bullet connectors;No female bullet connectors are supplied and must be purchased separately to complete installation. Worth the effortbecause thus light really cleans up the rear fender compared the hideously ugly OEM tail light and mount. Brighter than OEM light, too.Like another review here, I agree the light should come with a rubber gasket between the light and fender.
Hayden
2025-03-27 15:31:16
Read instructions they help with wiring since there not the same colors, for 2024 owners of the XR beware you will have to cut a little of the rear fender for right fitment
Rob in MN
2025-03-13 17:46:51
The light bolts right on to a factory XR650L fender, all that is needed with newer machines is to adapt the factory wires to the new tail light (5 minute job, highly recommend solder and shrink tube along wtih the bullet connector).The running light is much brighter than the incandesent factory light, and also brighter than the popular XR600/XR650R tail light.The brake light is even brighter, and VERY visable in the day time. Added bonus is the way this new tail light is designed, the light shines VERY brightly in the correct pattern to be most visable to traffic behind the motorcycle.Highly recommend!!
Mike
2024-11-22 15:26:00
works great
Recommended Products