-The hose is plenty flexible (not silicone floppy, but flexible enough and won't kink on itself).-The guage is easy to read, even though it's only 2" diameter (disclaimer: I have 20/20 vision).-The Presta valve adapter swivels (the gauge end is fixed).-All materials are good quality, especially for the price.-The glow-in-the-dark dial works very well (it is bright, charges easily and quickly from another light such as headlights, and retains its brightness for long enough to check all 4 tires).-The gauge is accurate and consistent.I tested this gauge against both of Joe's Racing analog gauges (32307 and 32317), and I prefer this one. The hose is more flexible than that of the 32317, but less flexible than that of the 32307--not that this really matters, as they're all just fine. The glow-in-the-dark dial works better than both of the JR dials, by a fair margin (brighter, whiter vs yellowish, stays charged longer, ...). Since it's a 2" diameter dial, vs the 2.5" of the JR dials, and since the numbers are boldfaced, rather than fine lined, it could be argued that the numbers are slightly harder to read (but no problem whatsoever for me, either way). All three of the gauges have adapters that are essentially the same; so, they all seal equally well, and all gauges come with the optional ball-gauge adapter and pressure release valve. The overall fit and finish of this gauge is a bit better than either the 32307 or the 32317. Perhaps most importantly, I did notice that the 32307 consistently read 1 psi below the Longacre and 32307, but the latter two were consistently the same. I assume that the 32307 I got was simply lacking in correct calibration. Finally, for what it's worth, the packaging of the Longacre gauge was nicer (plastic case vs shrink wrap to cardboard backing).As a final note, since none of these gauges come with a protective case, you may consider, as others have done, ordering a case such as the Caseling for Graphing Calculator Hard Carrying Travel Storage Case Bag.

I bought this and "TireTek Premium large dial gauge" that is couple of dollars cheaper than this one. Here is a comparison of these two side by side. Both gauges are way way better than the pencil type tire pressure gauges that I used to buy from Auto-parts stores locally. Both products produced NEARLY identical (but slightly different) pressure readings, when tested multiple times.Pros : This gauge gives more consistent readings than TireTek which would have small variations between readings (only about 0.2 PSI i would guess, but i liked the repeatability of this gauge). If i release some air using the pressure valve on this, the needle would immediately come and rest on the exact read (whereas the TireTek brand took 3 seconds to SLOWLY rise upto the proper reading). Longacre had more solid design and this was visible in the solid feel of the pressure release valve. The spring on Tiretek was not as good as the one on Longacre. The primary reason i decided to pick this over Tiretek was the hose, which made it lot easier to take readings compared to the "NO-hose" models. I can simply let the dial face rest on the floor, while i insert the other end into valve stem. There is 360 degree rotation of the end that will plug into the tire valve. Overall, this tire pressure gauge has a very solid feel to it, and you can sense that it will last many years. Well worth the extra couple of dollars, when i consider that this gauge has the solid feel of a life-time product.CONS : 1. Do not count on the glow-in-dark feature, which is very feeble - manufacturer could improve on this feature.2. The clarity and separation of PSI markings in the dial are lot better on the TireTek when compared to this. I feel that the dial is a tiny bit smaller than TireTek, which had easy to read PSI markings (even though both are touted as 2-inch dials). Using both of these brand names, You can see and get upto 0.5 PSI accuracy, with less than 0.3 PSI margin of error in reading. The markings are only at 1 PSI levels, on both of these brand names. TireTek has very clear white background, whereas the dial background is not as good on this one (but still very readable).3. You need to insert this into tire valve stem in one single fluid motion. If you hesitate or if you change directions during insertion, air will start leaking out of tire for couple of seconds, until you get proper seal. Whereas the TireTek Premium model did not leak air this much, and made proper seal instantly (once i got used it on two or three occasions/days). But this is something you will get used to and become familiar with, after few uses and hence is not a big problem, in my opinion.4. Last but not least is the fact that pressure reading will not be "HELD" (or shown) once you remove this gauge from the tire. But TireTek model i got will "HOLD" the pressure reading even after it is removed from the tire, so that you can look at the reading at leisure. If this one feature is added to this model, Longacre gauge will be the best one in this price range and unbeatable in comparison.Overall, i am very happy that i spent the extra 3 dollars to get this brand over TireTek. For the price, this is the best one on Amazon.

Accurate PSI readings as verified by other gauges. Easy to read gauge face. Precision air chuck (with angle attachment) which works well with every valve (metal and rubber) I tried it on. Easy to use relief button for fine-tuning air pressure. Not cheap, but worth the price.

Worked smoothly

I rarely write reviews of the things I buy on Amazon and when I do, it's never on the day I receive the item. I swear I could win an Olympic gold medal for procrastination!But I've been worried for days about a potential slow leak in one of my winter tires so I just HAD to try my new tire gauge tonight!You have to expose it to light (normal works well but blacklight is much faster) but the glow in the dark display is very practical for situations like this!I won't say I had fun checking my tires pressure, but it was something very close to it because right after I finished I also checked my boyfriend's.Turns out, all my tires were fine but my boyfriend's were between 27-31 PSI (vs 36 PSI recommended pressure) so I also got a chance to try my Dewalt air compressor, which also arrived today.Pre filling, the readings with Longacre gauge were the same as with the Dewalt tool, which makes me confident about their accuracy.Yes the gauge doesn't keep the reading after you remove it from the air valve, but this beats trying to read the metal gauge that pops out from the air compressor handle at the gas station ANY DAY.The other night, I had to do that past 2 AM in the dark under the cold Montreal October rain.No matter how hard I pushed the chuck into my right front's tire air valve, I could not get it to align properly so a LOT of air escaped and I couldn't put it back in.I was starting to think something was wrong with my air valve, but when I went to the garage for my antirust treatment, they checked that tire's air pressure without any issue and it was down to 24 PSI...The rotating chuck head on the Longacre gauge is a pleasure to use and you don't need to be as strong as the Hulk to get it to align properly with the air valves.It wasn't the cheapest option but you get what you pay for. I would highly recommend that gauge to anyone.

This gauge is the best I've ever used. I was constantly buying inexpensive ones from auto parts stores that didn't work very well and it was always a guessing game as to how accurate they where. I should have purchased this long ago as I would have saved money and frustration by the time I purchased all those cheap ones in past. Easy to read, can bleed air off with the valve on the gauge, extremely well built. It does not hold the pressure on the gauge when removed from the tire however the hose is long enough that you can hold the chuck on the valve and read the gauge while bleeding air off if required.

Everyday use for checking tire pressure on cars, truck, trailers & tractors

Bought this because my cheap air compressor came with gauge but found out it was off by couple pounds. My tires have been underinflated and wearing improperly. This one feels solid and seems quality, should have bought it years ago.