Your cart is empty.
Your cart is empty. For CAN AM OUTLANDER/ RENEGADE/ COMMANDER BELT REMOVAL TOOL.
A MUST HAVE FOR BELT/TRANSMISSION SERVICE.
Installation:
THIS BOLT WINDS CLOCKWISE INTO THE ONLY THREADED INSERT ON THE SECONDARY/DRIVEN CLUTCH TO SPREAD APART THE SHEAVES WHILE COMPRESSING THE SPRING FOR EASE OF BELT REMOVAL,
THEN JUST WIND OUT COUNTER CLOCKWISE AFTER BELT IS RE-INSTALLED AS YOU TURN THE SECONDARY/DRIVEN CLUTCH CLOCKWISE FOR INSTALLATION OF THE BELT.
BE SURE TO KEEP BELT IN THE CORRECT ROTATION DIRECTION ( IT WILL BE MARKED).
These 70mm bolts are the PERFECT length (Opens Clutch COMPLETELY but WILL NOT ALLOW OVER THREAD in and Over Stress Clutch Springs).
I have used these bolts for my own Can Am ATV clutches and they work perfectly to install a new drive belt
Dominic PA
2025-08-21 10:58:49
Works perfect for a 2013 can am commander. cant beat the price. zero issues... next time I need replace the belt I am sure I will purchase again because I am confident I will miss place this by that time.
Josh
2025-07-24 10:57:18
Worked as advertised
Customer
2025-07-19 10:11:05
Just what the doctor ordered
Jumper Hawk
2025-06-26 15:43:13
A bit pricey but not likely to find this w threads all the way at you hardware store
Clayton
2025-05-27 12:24:33
I bought this awhile ago, but finally used it to install a new belt on my Can-Am Maverick side by side. It did just what it was supposed to do and made it much easier to install the belt.
Jody Hoover
2025-05-19 09:59:15
It works perfectly…. But it’s a shame that it’s just a bolt
Gregory K.
2025-05-10 15:07:44
A+++
Jimmy D. Buchanan
2025-04-26 11:26:53
Threads all the way up as described.
Customer
2025-01-13 20:28:44
Worked
Recommended Products
