Your cart is empty.
Your cart is empty.Includes tank to bowl gasket, three patent-pending bolts, three nuts and ballcock coupling nut: Hassle Free: The bolt locks in place, so no reaching into the tank while tightening the nuts. Washer Free: A rubber seal is already molded onto the bolt. Rust Free: Since the bolt's head is rubber, water never comes into contact with metal. Please note: The 2" and 3" versions look similar, the only difference is size of the gaskets. Gasket measurements refer to the size flush valve they will fit.
AdVo
2025-09-04 15:07:53
I originally purchased two different tank to bowl repair kits at a local home improvement store. Those kits contained multiple rubber and steel washers, and steel nuts that were suppose to seal the tank. I installed each set multiple times, but I was never able to stop the leakage.I could not find a label on the commode or tank showing the manufacturer's brand, but I now think it's a Mansfield 160 with a three bolt attachment. The Mansfield kit was much simpler to install, the rubber gasket fit perfectly, the three bolts each have a built in rubber seal and nylon locking nuts. This kit sealed perfectly the first time, and seems far less likely to damage the tank or bowl porcelain. There is a YouTube video from Mansfield that takes all the guesswork out of the process.
arseattle
2025-08-09 19:10:55
I was a bit suspect when I purchased this, based on a couple of reviews. This was listed, on the Mansfield site, as a replacement for the model 160 and it worked perfectly. Incredibly easy to install and the rubber fit/filled the holes tightly with no leakage/seepage right from the start. An installation note: install all three loosely and then gradually tighten the two sides, evenly, making them level. Tighten the rear one as well but not as tight as the side ones . . .until the side one are sufficiently tight and the tank is level left to right; then do your final tightening of the rear one, bringing it level front to back. That was the advice I was given by a plumber and it worked great.
Craig
2025-06-18 15:13:19
replaced all the guts of my mansfield 162 toilet - this kit made attaching the tank back to the bowl really easy. the rubber attached screw made things simpler so I did not have to deal with washers. see before and after!
Joe Schmoe
2025-04-16 17:24:09
Seems to be working fine.
Customer
2025-03-31 17:29:31
Worked as described.
christopher j phillips
2025-03-14 11:48:11
good quality screws and gasket for mansfield toilet
Joseph Lackovic
2025-03-06 13:14:02
I have American standards toilets. Flushing was a problem put this Mansfield system in flushing every time. No wasted water
Tekcomp
2025-01-06 15:49:17
worked as expected, did not disappoint.
Recommended Products
