Your cart is empty.
Your cart is empty.This 3/4" NPT midsize high pressure heavy duty regulator is the relieving type, offering stable downstream air pressure over a wide range of air flows for accurate control, fast response and minimal pressure drop. Offset gage ports can also serve as two 1/4" NPT supply lines. Made up of an aluminum die cast body, balanced piston and molded rubber set, this regulator should be proceeded by a filter to eliminate damage. Maximum of 250 PSI and 220 SCFM.
GadgetGuy
2025-08-15 21:55:15
This is made in the USA and the quality shows. This is the best regulator I have ever owned.When I set this one at 55 psi the output pressure stays at that when the tank pressure is 55 or greater with no air flow. Wide open output airflow only drops it about 5 psi.All the regulators I have used in the past the set pressure would vary greatly and would drop as much as 20 psi with a lot of airflow and would go up as much as 20 psi when pressure in the tank goes way up.
G.O.M.
2025-07-19 12:51:49
Just what the Dr. ordered...well made, holds the adjustment with the lock-nut.Buy quality and be happy.
Tim Bowsher
2025-07-09 18:47:22
My old regulator was having issues at higher pressure settings. I run a booster that needs high flow regulated delivery. This one does a good job. Hardly a flicker to the pressure gauges. Pressure holds once set, no creep. It does what you want of a good sized regulator to do.
Pam Sharlow
2025-05-25 13:33:54
Love it… five stars!!
dee
2025-05-05 18:11:34
Most consumer grade compressors regulators max out at 150psi. This low end industrial grade regulator is a cost effective way to get the psi out of the compressor. The black spring cap is easy to remove to install the regulator in tight spaces. Easy to get to 175 psi out of the compressor now.
jd
2025-03-24 16:34:21
The media could not be loaded.
Ready4fun
2025-03-22 16:48:11
Last purchased and installed in 1/24 already leaking in 11/24. Previous one lasted 2 years this one 11 months. Wish I could find a better one that can last in heavy daily use.
TC
2025-03-03 17:47:30
replaced all the fittings and gauges on my 20+yo 175psi/26g compressor. everything was leaking at this point. this milton regulator is now mounted on the wall behind the compressor. unacceptable that the wall mount was $10 for a $65 regulator. i like milton products, and i wanted the T handle for ease of use. so far, no leaks. didn't have to disassemble the regulator to mount, whcih was nice.
Customer
2025-01-28 12:22:31
Fonctionne bien.
Eugene Caswell
2025-01-22 15:28:10
Best item purchased
Jimboh
2025-01-13 09:37:04
Worth the money.
Harvey Tetzlaff
2024-12-08 10:18:36
Easy to intstall.Name brand itemWhether or not it was made in USA or China. Preference to USA
Bruce Rupert
2024-11-17 13:26:02
Nice unit would buy again.
Recommended Products
$29.99
$ 13 .99 $13.99
$111.38
$ 44 .99 $44.99