Your cart is empty.
Your cart is empty.Product Description
Attach the guide rail using screws
Pull down the clasp and insert the MCB
Snap on the buckle
Installation completed
James Hale
2025-08-23 13:59:35
Irrigation control
Robert Jackson
2025-06-21 14:26:46
This is a decent little circuit breaker. It is a double pole which means both of the switches are either on or off together, they don't move independently. This is a 20 amp circuit breaker it has overload and short circuit protection. I love that it has LED indicator lights for whether it is on/off. Connecting the wire is easy with the screw down terminals. I'm using this in a camper so 20 amps is more than enough for my use case.
Oldshoes
2025-05-06 13:37:41
Tested and Breaks on short. Last week I installed a sub panel in shop to provide power for a 13 KW on demand water heater that calls for a 70 amp breaker. Well, I didn't have a 70 amp breaker, and I'm fresh out of limbs I can trade for stuff I need. I wired up this Pjerjzn 60Amp - She's working like a champ. I've been monitoring with an Amp meter - I've seen it go as high as 59 amps - no achy breaky so far. Hoping she'll handle a little over rated if need be - but I can't fault her if she's on the money either.5 Stars for The Pjerjzn 120/240VAC 60Amps Double Pole Circuit Breaker
JustMyOpinion
2025-03-05 13:38:40
I plan to incorporate this into a solar installation. I haven't tested this breaker yet, but it appears to be very high quality fit and finish. Will update review when I've completed installation.
Warren Thomas
2025-02-22 12:01:49
Just an additional 1/16†of depth in the lug clamps would probably make the difference between useable and unusable. Even fully torqued, stranded copper wire will loosen and pop out of the top lugs as the breaker gets maneuvered into the panel. The factory includes crimp spades to combat this problem, but that exposes too much live conductor above the breaker and the thinness of the spades totally defeats the purpose of using the correct gauge size.
cti2019
2025-01-27 20:30:04
I'll be using this as a cut-off switch for an industrial machine. It's a 3 pole machine, so I'm adding a 32Amp single pole breaker next to this one. Multipole breakers are generally just single pole breakers with a pin tying the switches together. The single pole fits perfectly beside this one, so I'm going to remove the 2 pole pin, and replace it with a pin that ties all 3 together. Of course, this is not my primary safety switch/breaker. The source comes from a proper 3 pole 40Amp breaker, in a distant panel. If you're thinking of copying this trick, make sure it is done in a safe way and follows code and safety requirements. Enjoy.
Novis
2025-01-11 10:22:26
Wanted a small dinrail AC breaker for use in a van conversion for a quick AC disconnect on a small appliance. This fit the bill perfectly, its compact, high quality, sits snugs and has an excellent build!
Tommyt
2024-12-27 12:49:34
Using this for A/C circuits in my campervan electrical system. Much more compact than the big fuse panel I had before! The included DIN rail makes install really quick and easy.
Recommended Products