Your cart is empty.
Your cart is empty.Moog Problem Solver products incorporate proven design and engineering features for like new steering, ease of installation and longer life. Moog is the preferred steering and suspension brand of professional technicians and NASCAR Crew Chiefs.
Eric
2025-08-26 20:14:22
Use these to replace worn out bushings on Bilstein 5100’s for a 2004 Tacoma. Pressing them in using a ball joint kit worked perfectly
Patrick
2025-08-24 18:12:26
The fitment was good on my '98 4runner, however they deformed almost immediately after a load was put on them and they did not improve the handling at all. The attached picture shows what they looked like after less than 40,000 miles; they are cracked and in worse condition than the stock ones that had 110,000 miles on them. I have since replaced them with Bilstein bushings which seem to be much more rigid. I do not recommend this part.
steven c.
2025-06-08 18:43:43
Looks like OEM. Unfortunately OEM is horribly under engineer..Be nice if they were made from Teflon
Bea
2025-04-26 14:58:41
Thank you
David
2025-03-18 15:04:13
Rubber tore immediately during install to reveal that the bushing sheath had rust ON THE INSIDE surface where the rubber bonds to the metal. Worst quality control I've ever seen. Moog should be embarrassed.
Hunt
2025-03-17 14:00:35
Fits 2001 Tacoma Prerunner, improve the handling without paying $300+ for new struts.Tip: renting the U-joint tool set from Oreilly Auto part made the job much easier.
nelson
2025-03-09 11:36:52
Saved me from buying a whole new shock that cost $300 each for my Toyota Tacoma 2004 4x4. Needed to pay a professional machine shop to take out the old one and press the new one it. Saved a lot of money.
Will E
2025-02-05 10:30:20
My gripe is NOT with the bushing (regardless of brand), but with Toyota's bad engineering design on this generation of Tacomas. This small bushing carries ALL the load from the shock/spring strut on the lower control arm. Unlike other designs where the springs actually ride on the control arms, this poor little part takes a horrific beating. Toyota should have engineered a larger bushing for this application. .... cheapskates.
austin
2024-12-31 15:39:36
Great works on stock shocks 2005-2015 Tacoma’sTorch the old bushings out and press the new ones in save me from buy new struts $$$
2012 FJ Cruiser
2024-11-21 13:18:20
Fit the Pro Comp coilovers I have installed in my 2012 FJ Cruiser. Easy Install. Rubber is a bit soft and it squished down low in the mount right away.
Recommended Products
