Your cart is empty.
Your cart is empty.Moog Problem Solver products incorporate proven design and engineering features for like new steering, ease of installation and longer life. Moog is the preferred steering and suspension brand of professional technicians and NASCAR Crew Chiefs.
karla carrico
August 7, 2025
Installed these on my 1997 ford F250 4x4. Beware, these are tough to put in!!. Pressing the old ones out. Pressing the new ones in. Requires 1/2" all thread rod. Washers, spacers, bushing, sleeves. In various combination to make it happen. I have a ball joint installation kit. There is not enough clearance for the big C clamp press. But the sleeves in the kit I did use. One tip. A 3/4 flat washer. Is just shy of the OD of these bushing. Making a great base to press the old ones out. The factory bushing are slightly rounded over. After they are installed. This will need to be bent back. So it can pass through the IFS axle. I use a Hugh pair if channel lock plyers. Don't have to be pretty. Hammer and chisel probably would be fine. One other thing. One of my axle brackets had to be removed. Just not enough room to remove the old bushing with it there. Hope this helps.
Aaron
August 2, 2025
Great, proper fitting bushings. The geometry straightens right up and correctes camber and helps bring back driveability. Good product.
cimmaron
June 29, 2025
Just wanted the rubber insert, my cups are in great condition, ended up ordering urethane bushings Without cups. I prolly didn’t read the ad. Great seller!
Peter S.
May 4, 2025
As pictured
Cousin Sven
April 29, 2025
These are a bit of a pain to get at to replace unless you remove the whole axle beam but its doable. Easiest way to get the old ones out I found was to drill and chisel out as much rubber as you can and then bend and hammer out the outer ring. Install is as easy and a few good pounds with a hammer.
w s
March 26, 2025
I only use Moog for suspension parts and this one did not disappoint. Install is a pain so do your radius bushings at the same time. Will be putting these in another vehicle in the near future. Much better response and less wandering
Rippy
February 3, 2025
Correct axle pivot bushings for dana 50 TTB, 1990 f250 7.3 idi 4x4.
Bantha Boss
December 14, 2024
Perfect fit on my truck. I suggest replacing the radius arm bushing as well since you'll have all the other steps removed to install these. It is MOOG K80006.
Customer
December 2, 2024
I haven't had to use these yet but seem to be very well made
Recommended Products
$31.71
$ 14 .99 $14.99
$11.77
$ 5 .99 $5.99