Your cart is empty.
Your cart is empty.Backed by superior materials and rigorous testing, MOOG sway bar links deliver reliable performance you can count on. MOOG problem-solving innovations ensure fast, hassle-free installation.
‘Yota fan
2025-08-31 12:25:10
The media could not be loaded.
Filmeister
2025-08-09 17:22:08
Products arrived on time. Exact inner and outer tie rods as well as front stabilizers replacement for my 2003 Toyota 4Runner. There is noticeable lesser road noise and vehicle handling is more stable. I had same brand rear stabilizers installed about a year ago and its still solid.
Kendall Hess
2025-07-17 17:35:49
Fits my 07 FJ fine. Definitely noticed a difference after replacing the old ones (140,000 miles). These also are a far better design than the original part because you can use a wrench to hold the back side while tightening or loosening the nut. The original ones have a hex slot inside of the threaded shaft which will either break or strip if you haven't had them off recently. I had to cut the nut off of my originals and replace them for this reason while replacing my struts.
N. McCann
2025-07-11 14:50:37
FIT ME 4RUNNER GOOD
Steve M920
2025-07-04 14:37:37
Purchased and installed June 2018. I was impressed with quality of components and “feel†of the sealed joints. Silenced an annoying clunk sound on my 03 4Runner. Early January 2019 I’m surprised to find surface rust on them. Doesn’t noticeably affect the performance at this point and being in the Chicago area rust is to be expected eventually but not this quickly. I’d still recommend them; they’re relatively inexpensive and easy to replace but hopefully they’ll last a few years.
Allen
2025-06-08 12:53:23
for my 12fjcruiser, the new ones mentioned wrench flat for holding the link when i ratched the nut in but I don’t see it. I had to use a torx bit to hold down each bolt shaft to install the nut. it was time consuming, satisfied with the purchase and outcome.
Rain Man
2025-05-27 18:49:20
After replacing the upper and lower control arm bushings, sway bar bushings, and upper and lower ball joints there was still a clunking noise when going over small bumps. Decided to replace the sway bar end links since the seals were cracked and the only thing I didn't replace. The noise is now gone and the truck drives like new again. This was all completed on an 06 Toyota 4runner V8. The other side is Moog K90683
Thomas Sharkey
2025-05-24 20:21:19
I used this to replace a part that I bought from a local store that had cheap steel that rounded off the bolt heads easily. The quality of the Moog is outstanding and it comes greased. The bottom of the bolt is squared off so a wrench could be used for additional resistance if putting an allen head on the end is not practical.
Sherry Doerr
2025-02-21 12:07:47
perfect
Andrey
2025-02-09 13:29:17
Was delivered Nov 28th 2018. Package was in good shape, the part made an impression of a fairly well made product. Has replaced the original link in 2007 4runner in December 2018. Fast forward to April 2019 (less then 3000 km of driving) - complete fail - the joint is very loose and doesn't function as designed at all, which makes sway bar wobling and producing noise. The warranty request has been submitted, will update the review depending on the manufacture response.
Lindsay Rheault
2024-12-17 12:24:37
Toyota technician physically demonstrated joint popping out of socket after 2000km of driving. Don’t waste your money.
Recommended Products
$24.06
$ 10 .99 $10.99