Your cart is empty.
Your cart is empty.Mopar OEM part that fits your specific vehicle.
Customer
2025-09-04 12:24:44
I got the upgraded tie rods and drag link and this worked to set the pitman arm in the right location.
K6
2025-08-31 17:41:57
Fit perfect on 06 ram 2500 this works with newer T style linkage only. Do not use for stock Y linkage. In fact do not use Y linkage at all its a horrible design, in my opinion its dangerous and defective. Update 2024.... This is the best thing I have ever done to my truck. The T linkage update (covered as a factory defect if you can find a cooperative dealer) made the truck steer better than new, the way it should have when I bought it. I lived with clunking, bump steering, and bad steering for years. If I had known how much of an improvement this would make I would have done it sooner. The old one coming off will give you a good fight so be prepared. I broke a pitman arm puller on this job. Modified a few tools and ended up cutting part way through the old one so it would crack where it gripped the spline. Then it finally came off.
O
2025-07-23 17:18:36
Solid, ease of install, nice fit..
Darren
2025-06-19 17:24:53
I bought this for several reasons: it's genuine mopar, it was $25 less than what the stealership wanted, you need it with the steering upgrade, and i was replacing my gearbox as well so i cut the old one in half with a torch so i didn't have to fight it to remove it. Arived timlely, it wasn't rusty as others said, and it was a direct fit without any issues. Would buy it again if needed.
James H. McCoy
2025-06-06 18:52:56
Is what it is. Revised OEM Part to reduce the angle at the drag link. It is NOT a dropped Arm. So it has a sloped end and soft angle at attachment point. Correct splines for OEM steering box sector shaft.
Justin A.
2025-05-25 15:14:08
I purchased this part for my 2001 Dodge Ram 2500 Diesel along with that whole upgraded 3rd gen "T-Style" steering so i can do the 4th gen steering swap on my truck.. After I finally removed the stock pitman arm and tried to correctly install This new pitman arm its diameter is too large to have a snug fit on the steering box splined shaft. I believe this Pitman Arm was NOT made for the 2001 model rams.. I am getting by right now with the 2nd gen pitman arm mounted to the 3rd gen steering, but i would rather get the correct angle pitman arm with a SMALLER diameter splined hole.. If anybody knows of one please let me know.. THANK YOU
Customer
2025-05-07 16:34:21
Not much to say about this piece other than it worked perfect for my steering upgrade on my 2005 Dodge Ram 2500. I used it with the 2009-2012 style steering linkage which is recommended. Paint it to prevent rust and install!
kyle
2025-04-10 10:50:14
Exactly what I expected. Oem parts
Rick
2025-03-01 13:26:38
This is a must if changing steering linkage from y style to t style. Puts all the geometry proper.
Customer
2025-01-18 15:12:18
Fit as it should
Recommended Products
