Your cart is empty.
Your cart is empty.EFI Fuel Return Line Kit; Incl. Two Buna-N Sleeves/Four Stainless Steel Hose Clamps; 3/8 in. Aluminum Fuel Fitting Factory Welded to Adapter for Leak Free Seal;
tom meyer
August 26, 2025
What a Great product, saved a bunch of time installing this unit to finish my Efi install. did not have to remove my gas tank and cut a hole in it. just remove filler neck remove about 3" then install this unit. Done. thanks
es
August 25, 2025
worked perfect just wish it came in 2 1/2 inch
allen in az
August 5, 2025
I made it work good on 1967 ford f100 in cab gas tank. It's really thin aluminum. It would be better made out of steel. then 5 stars. return line for a carburetor.
randall
July 19, 2025
Too big for my application. Too bad, looked promising.
Ronnie McSween
July 1, 2025
Easy to install!
PlatoPig
April 26, 2025
Quality product and great idea. Unfortunately it was 1/2" narrower than my fuel filler tube so wouldn't work on my '67 Mustang.
George
March 12, 2025
So easy to install and better than having to drill a hole in the tank.
STEVE C.
March 1, 2025
Check it over carefully before slapping it in. Mine needed 5 minutes of deburring. The 3/8 return bung had a good burr where it was cut off. Getting the burrs smooth makes the hoses easier to push on. The 3/8 return tube is aluminum. So don't overstress it. I could break it with my fingers if I wanted to.
Customer
January 15, 2025
Instruction state to cut 3†off of existing down pipe.On my installation this would leave the clamps in the trunk under protective boot that is too small for connection and clamp. Was supposed to be a “fit†is not. Significant planning and time needed for what should have been an easy task
Recommended Products
$40.26
$ 19 .99 $19.99