Your cart is empty.
Your cart is empty.Curtis
August 1, 2025
To all that have a 400ex that was wondering would this item fit...it does...and looks great to me because I was looking to add some bling to my oil cooler...the dipstick is shorter than the 400ex stock dipstick...but it you keep your oil level properly...shorter will not be a problem because this Amazon dipstick will measure the oil highest point... I'm not sure how well you will be able to measure the temperature of the oil in the cooler...haven't checked that yet...however it only tappers out at 100 degrees...the look is all I cared for tho.
Shannon
July 31, 2025
Fits on a Honda XR650L, sensor is a little short but does read oil level at the very tip. Needs an o-ring where the sensor threads through the cap. Mine leaked at higher RPM/oil pressure.
Stephen G Cox
July 9, 2025
Fits well on my XR650L. However, its significantly shorter than my stock dip stick. Which means I need to either carry my stock dipstick when I travel or niggarig something to make this dipstock longer. Anyone that owns an XRL knows how temperamental the oil level can be on these bikes. There are times when it has plenty of oil but is hot and thus shows no reading on the dipstick. And there are times when the reading show "high". It fluctuates. Fortunately, the bike doesn't seem to care as long as it has enough oil in it to function. Having said this, this dipstick needs to be submersed in oil to get good reading. Therefore, the readings are not always accurate. I might order a longer bitherm from the kitchen section of amazon and see if that works better.
Costa C
May 30, 2025
Fits mopeds....
Stephen Martinez
May 20, 2025
Looks perfectly for my ice bear champion 2020 125CC nice aluminum finish nice upgrade for my trail bike.
Greibal Y. Ferrerras Bello
May 5, 2025
The media could not be loaded.
Daniel B.
April 15, 2025
First of all this is drop in for qmb139, but had no markings for oil level so make your own. Also, it arrives incorrectly set, so grab the probe and looking at the gauge turn it clockwise to the correct temperature. I also had to add a bit of rtv where the actual thermometer meets the cap. The threads need cleaned up a bit, but it’s a $6 part.
Cliente
April 13, 2025
Pésima qualità filettatura mal fatta arrivato provato non idoneo subito alla spazzatura soldi buttati via
N. Volle
March 25, 2025
Kann ich nicht bewerten,ging zurück
Steve Leduc
March 20, 2025
quality was low and it feels like something that you buy at a dollar store. I repurposed it into a dipstick breather
Christina
March 3, 2025
No good oil leaks past the thread
Niko
February 12, 2025
deswegen kaum lesbar.
Recommended Products