Your cart is empty.
Your cart is empty.vashon
2025-09-03 17:24:54
It worked for what I needed it for
Sara
2025-08-22 14:43:05
I used this to hide a gap between my wall and floor. It stuck well and was very flexible. It does however had an odor (kinda smells like tires) just so people know.
Nadar under the Radar
2025-08-21 19:37:35
I am using these on a 1885 C20 Squarebody that I am replacing the entire fuel system. These are used as anti-squeak to protect from metal to metal contact really worked good.
Wesley G. Brown
2025-08-16 17:22:33
I use this product to help seal a truck bed cover at the tail gate. Does what I expect.
Your moms friend
2025-08-03 15:26:33
Insulating
Zachary burgesser
2025-06-24 18:12:52
Applied this product to a mental table for traction against other metal parts. It's been on there for 4 months with no issues and provided the right about of protection without being too bulky
Ronald H
2025-04-27 12:59:53
I got these strips to act as bearing surfaces for a sliding table I built for a tablesaw. The idea was to reduce vibrations and noise as the table moves on transfer bearings below it.I found the rubber to be sufficiently hard to move smoothly while damping the noise significantly. Also, the adhesive backing caught strongly and will presumably last long.
Rick m.
2025-04-17 13:59:51
Good and sticky worked great.
vashon
2025-03-28 17:10:48
It worked for what I needed it for
Sara
2025-03-18 15:46:24
I used this to hide a gap between my wall and floor. It stuck well and was very flexible. It does however had an odor (kinda smells like tires) just so people know.
Nadar under the Radar
2025-03-01 18:28:06
I am using these on a 1885 C20 Squarebody that I am replacing the entire fuel system. These are used as anti-squeak to protect from metal to metal contact really worked good.
Wesley G. Brown
2025-02-18 18:57:27
I use this product to help seal a truck bed cover at the tail gate. Does what I expect.
Your moms friend
2024-12-07 10:14:49
Insulating
Zachary burgesser
2024-12-02 14:02:29
Applied this product to a mental table for traction against other metal parts. It's been on there for 4 months with no issues and provided the right about of protection without being too bulky
Ronald H
2024-11-26 17:28:01
I got these strips to act as bearing surfaces for a sliding table I built for a tablesaw. The idea was to reduce vibrations and noise as the table moves on transfer bearings below it.I found the rubber to be sufficiently hard to move smoothly while damping the noise significantly. Also, the adhesive backing caught strongly and will presumably last long.
Rick m.
2024-11-18 10:37:57
Good and sticky worked great.
Recommended Products