Your cart is empty.
Your cart is empty.KeetRC51
2025-07-11 17:06:36
If your leveling jacks and or slides stop working, before you do anything else, replace the leveling jack motor on the pump. This was a perfect fit and replacement for my 99 Winnebago it took me an hour to replace the motor, and it works better than it ever has.
MGH of Kodiak
2025-06-12 12:39:11
Did the job Great fit and works well.
Christian Ryman
2025-05-12 11:32:30
Purchased this to replace the RAP90311 motor on my AP2260 HWH 210 series levelers on my 1999 Damon Challenger motorhome. This was an exact fit and works great at half the price of going through a local rv shop. I couldn’t be happier. Now my jacks are back up a going ðŸ˜
Robert K.
2025-04-18 20:44:38
Just finished installing the motor in less than a hour for removal and installation, works perfectly.
Steven
2025-03-01 14:45:35
The leveling pump motor on my 2000 Dynamax Isata with HWH 610 leveling system stopped working. This was a perfect match replacement. Took about 30 minutes to remove the old unit and install the new one. It has a connector for a ground wire so I added that. Sure fast shipping too. Very pleased.
rdub
2025-02-26 18:12:18
First off, now that it is installed the pump motor works great. I am giving it 3 stars though as the install process was complicated. Instead of taking me 15 minutes, it took 90 minutes and a phone call.When the motor went on my RV leveling system, Amazon was the first place I turned for a replacement. Matching the part number, I was able to quickly find and order one. It arrived sooner than they estimated.That afternoon I crawled under the RV and since I already had the old one out, figured this would just bolt in. However, when I went to install it, to my surprise the mounting holes didn't quite line up. Although the thread was correct, the alignment of the two mounting holes between the motor and the aluminum plate were off by literally less than 1/8 of an inch. This small amount would not let the mounting bolts thread in.A bit frustrated, I called the number on the paperwork in the packaging and spoke with the owner of the company who said the motor was built to manufacturing specs and then said he would work with me and ultimately happily return it if it didnt work. He suggested if I had the ability, I could try to modify the part and would still return it if it didnt work out. Not knowing of another option and knowing I could still return if it didnt work I figured go for it.So I literally took the motor casing ends apart, used my drill press, and bored both ends of the aluminum cap mounting holes laterally outward with a step up larger bit (I believe it was 1/4"?). I then cleaned everything up and reassembled the motor.When I crawled back under and lined everything up, I was happy to see all lined up. Once I tightened the bolts down and made the electrical connections, the leveling system was once again working!So in the end it worked out but took some time to do so.
Gary D
2024-12-19 12:24:10
Perfect fit and works great. Quick shipping and it is just exactly what I needed.
Lester Honeycutt
2024-12-13 12:53:43
The motor bolted right up to my hydraulic pump and works great.
Recommended Products
