Your cart is empty.
Your cart is empty.Product Description
-
Use them together
CP-180 Hand Pump
NEWTRY provides jacks of 5-50 ton. 5-20 ton single jacks are suitable for cp-180 hydraulic pump.
-
Plastic dust cover
ZG3/8" Joint
The jack adopts threaded ZG3/8" joint and has a compact structure.
-
Small Size
Mini and Compact Design
Mini type cylinder, lightweight and compact design for narrower and height limited workspaces.
-
Firmly Fixed
Smooth Surface
The surface of hydraulic ram cylinder is painted with lacquer, which is not easy to rust.
-
ZG 3/8'' Fast Connector
Pefect Connection
ZG stands for sealed tapered pipe thread and 3/8 is the nominal diameter of the inch thread.
Choose the Right Size
-
-
-
-
Tighten the Connectors
The male connector on the jack and the female connector on the pump must be tightly screwed, or the oil will leak.
steve gafford
2025-07-21 10:04:52
Item was as described, and performed as desired. I used it as a flange spreader along with some shims i provided to take up the space between the stroke of this jack and the span between the flanges. Made short, struggle-free work of a valve change-out that could have otherwise been a nightmare.
Customer
2025-07-20 18:36:44
Great customer service. Unit works good.
Chuck Neely
2025-05-30 09:00:13
Worked great once. Did not work again. I entered the service email incorrectly. With the correct email I received a prompt reply overnight. We are still working through the solution. I will post again based on the conclusion. Sorry for the original misguided post.
Forrest
2025-05-16 14:27:38
This little ram worked great for the job I bought it for. When my truck got rear-ended, the truck’s built-in hitch got pushed down, mushrooming up inside the truck’s frame where the hitch was attached. The mushroomed point was several inches inside the frame, making it pretty much impossible to flatten the metal back down using normal tools. The little hydraulic cylinder that comes with this porta-power kit fit inside the frame just fine, but the ram's stroke is only about a quarter inch, so it was necessary to stack various pieces of metal in with the cylinder, and work at the mushroomed metal a little bit at a time. Not easy, but doable. The frame is flat again, and the hitch now sits straight.I took a chance when I bought it, as nowhere does it say the size of the hydraulic cylinder that does the work; I was not at all sure that it would fit where I needed to use it. So, if you need to know: the hydraulic ram is the Newtry FPY-5, ~40.5mm high (when collapsed), and 48mm wide.The unit seems to me to be well made, and worked straight out of the (heavy-duty cardboard) box. I’d give it five stars but for the fact that the accompanying written material is virtually unintelligible. There is a troubleshooting chart, for example, but I have no idea what information it might be trying to pass along. The company really should hire an English-language speaker to write their material. I do have to give them credit, though; their English is way better than my Chinese.As I said, the tool worked great for me, and it’s paid for itself even if I never use it again.
luis santiago
2025-04-30 13:40:50
Great customer service… I had a problem and they contacted me within minutes and took care of the problem. Definitely recommend it
RUSSELL H GALLINAT
2025-03-22 11:23:11
QUICK SHIP GREAT PRICE
Thomas
2025-01-23 15:10:18
We are very satisfied with this product. You saved a lot of money and this works as expected. The quality for the price can’t be beat.
Scott R.
2025-01-16 13:07:03
Will only work in a perfectly straight push, any side load will not allow jack to retract.
Recommended Products