Your cart is empty.
Your cart is empty.Product Description
519-CCB2218L
About NICHE
NICHE specializes in the highest quality Powersports replacement parts. Our parts meet or exceed the quality of the original parts that come with your machine. Some of the NICHE product categories include cylinders, brake pads, axles, off-road mirrors, and drive chains. Let NICHE components fix your machine today!
NICHE Rear Hand Brake Cable 519-CCB2218L
Cable Type: Rear Hand Brake Cable
- Includes: Rear Hand Brake Cable
- Compatible with the following brands: Kawasaki
- Compatible with the following models: KVF 650F Brute Force 650 4x4i,KVF 650G Brute Force
- Replaces for the following OEM MPN's: 03-0373,54005-0005,54005-0017
Cable Comparison
Clutch Cable
What is it?
- A clutch cable allows the vehicle to change gear
Why Replace?
- They break, the constant stress of the cable sliding in and out causes a break at one of the end.
- The cable casing gets damaged due to being close to moving parts, damaged housing causes the cable to bend and corrode.
When to replace?
- A common sign that your clutch cable is damaged and needs replacing is if the clutch lever is stiff or your gear shifts aren’t smooth
Throttle Cable
What is it?
- The engine of your bike needs air and fuel to run. When you turn the throttle, it connects to the pull cable and pulls open the butterfly valve. This allows air to enter the intake manifold
Choke Cable
What is it?
- A choke cable is designed to restrict the flow of air in the carburettor of an engine
Choke Facts
- There is no harm using the choke to start an engine. When it’s cold, it can be a necessity to get started
- Using it a choke will only lead to increase fuel usage, but no damage to the vehicle.
Pull Throttle Cable
What is it?
- This is the cable that pulls open the valve when you turn the throttle. It allows air to get into your engine
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
Push Pull Throttle Cable
What is it?
- A dual cable throttle operation where the pull cable opens the throttle plates, while the push cable, along with a throttle return spring, closes the throttle plates
Installing Tip
- When installing a new cable, make sure to note the routing of the original cable. Also, the dimensions of the new cables must be identical, allowing for the fact that old cables do stretch over time.
Maintenance
- After a race or as often as possible after washing to remove the cables from the bike and flush them through with a blast of air. Also the nipples can also be lubricated, with copper grease
Push Throttle Cable
What is it?
- The push cable is a safety addition, there is a spring that will close the valve whenever the throttle isn’t activated but if the spring fails the push cable safely closes the valve.
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
Jason
2025-07-27 09:22:00
Worked great on Kawasaki 650 prairie,
belinda
2025-07-25 16:26:29
Fits works great ðŸ‘
G. F. Christensen
2025-06-29 13:53:01
The ATV design leaves this cable particularly vulnerable to corrosion damage, add in a little pressure washing to make sure the water gets in, and you are going to need a new cable.This part has all the same dims as OEM, appears to be made out of similar material and workmanship. The boot is suspect, but it sucks on the OEM Kawasaki part too. Has functioned perfectly for a few months now. I am going to order another as a spare, Very happy with purchase.
nic go
2025-06-28 10:56:21
So far so good! Brake lines been installed for almost a week now and everything seems to be working great!
Bryan
2025-06-20 11:37:13
The cable is the right length and cable ends fit, the sheath end for the rear brake did not fit the bracket
Steve Sandridge
2025-03-16 17:45:05
Fit kawasaki brute force 750i 2006 perfectly .
Ken Tereck
2025-02-23 09:25:33
fitment and quality were excellent
J Marsh
2025-02-18 15:16:55
Works great, fast shipping.
marc
2025-02-13 16:17:09
Fit perfect and fast delevery thank )
Greg anderson
2025-01-11 11:28:53
It fit perfectly as it should , pricing was also good
dave
2025-01-05 14:44:25
If i could give this less than a 1 i would, not only have i wasted my money on this i have also wasted my time trying to fit it. The sleeve which is supposed to slide in the rear mounting bracket is to big. In the picture the old cable is on the left and new on the right. As a result it can not be connected to the brake lever on the diff.
Recommended Products