Your cart is empty.
Your cart is empty.Product Description
LukeSkyWalker
2025-08-12 13:55:20
Exact and snug fit on my 2024 Chevy Silverado 1500 RST Crew Cab.These window visors are way better than the ones I already have but for different vehicle models. I have several installed on my vehicles all outside mounted using double adhesive tapes. Over time, the adhesive tapes will eventually dry out especially here in AZ, and will soon begin peeling off either from the vehicle's door frame or with the visor itself. Plus the double-sided adhesive tape leaves a nasty hard-to-remove residue from the door frame.These NiLight window deflectors (select fitment) are better.1. Easy to install inside the window rubber seals. Make sure to position the right visor first on whichever door you will be installing2. Visor for each window/door is longer, it will fit snugly in the window glass rubber seal. It requires a little bit of bending (don't worry it won't break) to get the visor fully seated inside the rubber seals. Make sure the windows are all rolled down. I decided to leave and not use the double adhesive tape on the visors. Once a visor is fully seated inside the rubber seal channel, you can tell that it won't easily come off even when driving. Plus, if you decide to remove the visors it would be easier not to get those tapes sticking inside the rubber seal.3. It comes with a dozen of metal clips. I used 1 each for the front visors and 2 each for the rear. Make sure to put the clips in an open rubber seal channel (gap) then push it gently using the plastic tool (crowbar) until you hear it snap into place.4. If you are installing this same as my vehicle, make sure to put tape beside the side mirror door rubber molding/seal where the visor tip meets with the end of the window frame to prevent it from getting scratched or peeled off during the installation. Once the front visors are fully seated and aligned, you can remove the protective tape by peeling it off.5. Final step - make sure to test windows operation by slowly closing then observe if the clips are in obstructing the glass from closing completely. My install did not have any issues except for the driver-side auto up/down at first the window bounced back when I rolled it up but after another test, it rolled up smoothly with no issue.It looks great on my truck. Like other reviews, the visor is a little shy of width.Overall, I am satisfied with my purchase of this product.
The Clarks
2025-07-26 13:06:57
Love these visors! Wish I had gotten them sooner... they been on for 4 months now and are holding up to the weather perfectly
Robert Boyle
2025-07-21 17:22:01
Works good but wish the tape was a little better. Do work tho
Jason W.
2025-06-21 09:20:53
Great fit, easy installation and they look great
Genefar
2025-05-28 18:38:55
Easy to apply in minutes, gives a nice look to the truck. I have had them on for over 6months with no issues.
Kevin B.
2025-05-14 10:13:03
Horrible fit. Horrible tape. The tape they come with is useless and the fit is really bad. Causes a huge bowing in the visor.
V. Spencer
2025-04-29 16:04:13
The item fits and looks good. However, the clips that were included were not as described in the instructions are are unusable. I will have to find other clips to secure the guards in place, as the double sided tape is not substantial enough to hold the guards in place.
Oakdale58
2025-04-18 18:14:42
Fit very well and the small clips keep it in place Makes it nice to have the window open enough to let the air move around
Schleffie
2025-03-21 11:30:26
Fit exactly how it should, very nice product.
Sam
2025-01-29 18:33:44
Installation was iffy.Front guards fit perfectly. Back ones, not so much. Back ones were loose, but good old double sided tape held them. Female installed.Very happy with them atm.
David truchon
2025-01-07 21:46:21
Excellent
Thomas
2024-12-23 11:22:04
Installed waited the 48hrs then opens the windows and they pretty much all fell out….. Trash for the amount I payed
Recommended Products