Your cart is empty.
Your cart is empty.Product Description
Nilight 4Inch 12LED Red Round Trailer Tail Lights
- Working Voltage: 12V DC/ Waterproof Rate: IP67
- LED Quantity & Type: 12PCS 3030 SMD LED
- Tail light size with rubber grommet: 5.3” diameter, 1.87” depth
- Rubber grommet hole size for surface mount: 4.46” diameter, 1.87” depth
Main Features
Two Lighting Modes
Double lighting brightness functions, high brightness for Stop/Brake/Turn signals light while low brightness for Tail light.
Stand Out Brightness
Nilight tail light output 3 times brighter light than others. Whether it's day or night, the mode transition can be clearly seen by the vehicles behind.
Tightening design
The outer ring of the lights and the rubber grommet can be firmly combined together. The equipped 3prong plug can be easily inserted into the back hole without falling off.
IP67 Waterproof
Highly silicone sealing. IP67 waterproof rate, resistant to water intrusion, durable with any season and weather.
Install Steps By Steps
Work on 12V DC , all kinds of Trucks, Trailers, Boat, RV, special vehicle, etc.
Shawn Young
2025-08-16 10:51:25
very bright for now. these last a few years in my experience and then need to be replaced again due to sunlight fogging the lens.
Van D.
2025-07-01 10:54:29
If your tired of your old tail lights not lighting up behind your rv,then these items are a must..Easy installation and bought 2 sets ,one sets tied to tail lights circuits and the other sets just on a manual switch in rear compartment area to stay on until the toads unhooked…If your sick and tired of just plain darkness and awful blind spots these are something to buy…I’ve installed 1 set low about car bumper height,wiring going to reverse tail lights line ,and the second sets up higher to manually turn on to unhook rv tow car ,trailer,or anything that’s back there…Who wants to get into the darkness and fall while working outside on the back side…Now looking at a set ,to use as extra lights on side areas hooked to a motion sensor…good deals and packaging was great…and the chrome outermost rings make it a nice installation,smooth and flat …Just use the right size hole saw cut out hole,and I put some larger marine plywood with the same size hole into it,but make the backing about 2-3 inches larger than hole itself,then there reinforcements on both the light and body of rv or trailer..
Kyle
2025-06-26 16:49:00
Replaced ancient and barely functioning lights, and added reverse lights! I had to rewire the entire trailer anyways, so I was able to wire it properly for these although not original. Aside from revitalizing the brake/signal lights, the bright reverse lights have unexpectedly become my favorite feature! Surprisingly pleased with these.
S-Door
2025-05-31 13:14:02
product works very well ,price and service very good
Jenny
2025-04-28 16:39:18
Great quality and fast delivery Perfect fit
Customer
2025-04-06 17:27:21
for older vehicles you will have to upgrade the relay in the fuse box for the flashers to work, $8 cost for the relay at any automotive supply store...
KD
2025-03-30 12:49:38
Replaced an old set of incandescent lights on a pintle hitch trailer; total of 6 lights. Very happy with the improvement. Bright, bright, bright. Definitely a good upgrade.Tip for installation: I popped the new rubber grommets in place,.. sprayed a little wd40 on the fixtures and still couldn't get them to pop into place. So,.. I placed the rubber grommets in boiling water for a couple of minutes. This softened them up just enough for the light fixtures to pop into place. Highly recommend these lights.
John
2025-03-20 18:01:18
Nice bright work good body flush mountad ... WAY IMPRESSED WITH BRIGHTNESS!!!
JCB
2025-03-16 13:32:29
Well built and easy to install. The gasket is super flexible and holds the light housing in place. Lights are bright with time telling on their longevity.
Pierre Benoit
2025-02-03 15:42:16
Unfortunately I didn't use these light and returned them with full credit. I sold my truck before installing them and didn't need them. They would have looked great.But I do recommend them.5 stars.
River
2025-01-09 12:33:19
These lights check out the best out of a handful of other retailers both local and on amazon (In the 4†led department anyway)I removed the grommet from the light and popped the grommet in the hole. Then followed up with nilight’s amber led.The grommet fit my oem 4 1/2†hole incredibly tight and I'm stoked. In my case I had to push hard and work the edges in. The “oem†seal I bought just in case didn’t fit at all. bought a whole set of tail lights since the grommet fit the factory hole so good. Im confident it won’t leak.Nilight has a good selection. Look forward to more. Price is high but quality is higher.
Christian B.
2024-12-18 14:39:39
Looks good
Yoryo
2024-12-12 15:01:57
N’est pas 4†ou 5" conventionnelle
Recommended Products