Your cart is empty.
Your cart is empty.C. Nigrelli
August 19, 2025
Different color board but the same OEM part number and layout. I just matched the old boards wire locations to this new identical board wire location and it save me a bundle on a furnace repair bill. Heat is on and all is working great again. I already knew the board was the problem, and I feel comfortable working on things like this. If you don't want to DIY, and just want to save money on the overpriced parts a repair company will charge you, just buy the OEM part and let a pro do the labor for you it should take less than 1 hour total time, but you will still save money!
Norbert Szumlański
July 7, 2025
Works well , no issues
Robert Older
July 4, 2025
My original board burned out due to a power surge. I replaced it with this one but until the A/C people come I won't know if it's working. Was easy for a do it yourself to install, just take your time and match up the wires the same as on the original board. PS A/C guy came a fixed another problem caused by the power surge SO this board is working great now I do suggest this board if you're a DYI kind of person. This saved me a bunch of $$ thanks for an easy DYI project.
Branton Robinson
June 26, 2025
I have heat now
Easy
May 30, 2025
Exactly as pictured and described, identical to original board. Plug and play very satisfied. Highly recommend if you need a replacement.
Jane K from Athens, GA
March 16, 2025
Easy to install.
William G. Taylor Jr.
January 11, 2025
Quality product and worked flawlessly once installed. Make sure to label all the leads and take pictures. This was a 30 minute repair and saved me a ton of money fixing the AC Board myself.
Randy
December 2, 2024
This IFC (MOTHER BOARD) did not get my HSI (the hot surface ignitor) hot enough either because the amount of time and or the amp to the HSI WAS TOO LOW AND NOT NO LONG ENOUGH TO LIGHT THE LP GAS. It was for an 80% furnace. Not a 92%..and the ignitor was only a 80 volt. My unit needed 120V. I screwed around with this for weeks and weeks. It would light some times but not every time. I finally bought a used board from EBAY for $80.00 and it light the first time and every time for a week now. So if you see that the HSI is not red/orange hot for at least 3 to 5 seconds then you will know its the wrong IFC / mother board. Good luck to all.Trane D341396P01 White Rodgers 50A65-475 Furnace Control WORKS IN A 120V TRANE FUNACE XR90 OR 95 BUT CHECK EVERY NUMBER AND LETTER BEFORE PURCHASING ANY BOARD. Nothing worse then climbing up in a hot or cold attic bent over on your knees, metal knees at that and troubleshooting something. Rear but also can go out is the pressure switch. Mine tested good 4 out of 6 times. you may want to bench test your vacuum pressure switch before replacing too many other expensive parts. NEVER SUCK TOO HARD OR YOU WILL BLOW IT UP. its like trying to blow a fether to get it to move just a little bit, not blow it off the table.
Recommended Products
