Your cart is empty.
Your cart is empty.Ray
2025-07-12 14:08:22
I have these installed on three different axles and they all work perfectly. They eliminate axle slop and binding that is common wit the stock style shafts. You will have to remove the outer bearing from the axle housing to get the joint to fit into the assembly properly, but once you do everything will go back together. These axle shafts will allow for much more steering angle with a simple google search on how to modify the parts properly. Excellent quality for the price for sure.
Beantotem
2025-07-06 10:38:07
These CVDs do what they're supposed to, but they are not magic. I replaced the stock dog-bone in my SCX24 Deadbolt with these, which helped a bit. As far as I can tell, binding during sharp turning was eliminated. I went a step further and ground back the plastic where the axle interferes with drag arm, which helped reduce my turn radius further. For the price, I would recommend picking up a set when you've completed your first round of upgrades for the SCX24.
Erik Mendoza
2025-07-02 13:09:39
Have had them on my scx24 for 2 years so far and they take all the abuse never have to worry about breaking anymore
Molly+Jessi
2025-06-28 18:57:28
Don’t work. Lots of binding. Made a lot of effort to get these to work. They’ve changed or I got a bad set. They are not usable.
Ted
2025-06-11 13:00:12
These axle shafts are a good upgrade over stock, but they aren't going to work miracles. The bouncing issue with the stock dogbones is greatly reduced (but not eliminated), and they provide a slightly tighter turning radius. Manage your expectations and these are a pretty nice upgrade.
Josh
2025-05-14 17:36:59
Extensive modification of the stock axle housing and shaft flats is required two stars because they are made good
Matteo
2025-05-04 18:58:59
I have an extreme steering rate for my rig so I except and still have some binding issues on full turn. However, this seem to be doing a lot better than the standard dog bone style shafts that imo will always need to be dremeled down to avoid binding.I gave it 5 stars because I wasn't expecting anything more or less and fit my needs perfectly.Just make sure you lube heavy, install correctly, and you should be good to go. Good chance a bit of a break in period as my binding has been less and less.
Charlie
2025-02-04 10:54:22
Regular shafts will fit the ORGC +5mm axels not the +5mm option 🙄 😑
Recommended Products
