Your cart is empty.
Your cart is empty.Product Description
- Oiyagai 5.08mm Pitch Male Female PCB Screw Terminal Block
Quality plastic:
- High quality plastic.These screw terminal blocks are strong,not overly-brittle as they are being used. And grip the wire properly and also are mechanically well made.They features quick disconnecting,makes these terminals much easier to swap out to another device without having to cut all the wires.
Strong grip:
- The legs are long enough to hold in a breadboard.Pins are strong and grip the wire properly and also are mechanically well made.They are tight and snap together well so you can avoid wiring connection problems such as intermittent contact and else.
Switch easily:
- These blocks have a quick release capability,it's helpful for connecting lots of wires to an breadboard/device.They features quick disconnecting,makes these terminals much easier to swap out to another device without having to cut all the wires.
Stack operate:
- They can be "spliced" together.For a certain pin spacing,a number of the connectors can be place end to end (stacked or strung together as the length of each connector is consistent).Hence,one does not have to waste space between of connectors.
Quality plastic:
- These screw terminal blocks are strong,not overly-brittle as they are being used. And grip the wire properly and also are mechanically well made.They features quick disconnecting,makes these terminals much easier to swap out to another device without having to cut all the wires.
NoName
2025-08-24 09:03:41
These connectors are quite nice. I purchases both the 2 pin and the 9 pin connectors and intend to purchase more. They are strong and grip the wire well and are mechanically well made. They are tight and snap together well so I do not expect wiring connection problems such as intermittent contact. (I am still working on my project.) Also important to me was that for a 0.200 pin spacing (5.08mm) a number of the connectors can be placed end to end (stacked or strung together as the length of each connector is exactly an integral multiplier of the pin spacing. Hence, one does not have to leave any dead space between of connectors. I need to to have about 30 screw connector positions and they stacked fine. Most of the connectors that are on Amazon have extra material at the ends and so will not string (stack) together.Another review mentioned that the pins are 0.040" square and so do not fit in a 0.040 diameter round hole, which most proto-board are suppose to be designed to. This is indeed the case and so one either forces the pin through the hole or has to resize the drill hole. A #54 drill bit at 0.055" works well for enlarging the holes at the expense of lost of the through connection material.I found a very nice, clean, proto-board that had well defined holes and solder pads worked well for this re-sizing of the holes and re-drilling went smoothly.https://www.amazon.com/gp/product/B07FK41NG8/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1For some reason a typical broad search on amazon does not bring up these boards, but the supplier site will with some searching.
Tacaño Anciano
2025-08-16 13:31:47
Based upon initial use, these work well. I am happy with this purchase - thanks.
Customer
2025-07-31 10:03:00
Product was as advertised. Worked perfecty
John R
2025-07-10 12:15:47
These terminal blocks are well made and the wires attached firmly. I especially like the quick disconnect connecting block that makes these terminals easy to swap out another device without unscrewing all the wires. I would definatley recommend these for connecting lots of wires to an electronics project/device.
Christopher Hilling
2025-07-09 12:47:30
The product was as advertised. The only feedback is that the blocks came with the wire screws tightened. I needed to loosen the screws to land the wires. This increased my installation time
William Monroe
2025-07-05 11:40:52
Just as advertised
172pilot
2025-06-20 13:16:01
I haven't used these yet, but they're exactly what I was looking for.. I wanted to make some connections to a circuit board which I could connect individual wires to, but still have a quick release capability.. These will do nicely!
James Lansberry
2025-06-15 10:00:34
Works like it should and is exact fit. A bit bulkier on the wire end but not any issues at all.
Pietro
2025-06-09 16:42:40
Perfetto, arrivato puntuale e la merce era come l' avevo richiesta
Ruggero Sguera
2025-05-29 12:43:53
Ottimo
LEBLOND
2025-04-28 11:20:44
Bien pratique pour réaliser un raccordement en fils à fils avec possibilité de déconnecter les deux connecteursLiaison d'un contrôleur de led 6 conducteurs vers une bande de led 6 circuits.Parfait
Bodo N.
2025-01-30 10:15:17
passt auf die Schrittmotortreiber
JULES Philippe
2024-12-19 11:37:28
J'ai utilisé ces connecteurs pour relier électriquement un tableau principal fixe de forte intensite avec des tableaux de commande mobiles dont le courant est beaucoup plus faible. Ces connecteurs enfichables sont parfaits pour ce genre d'application. Je suis donc très content de les avoir trouvé à un prix raisonnable pour terminer convenablement la réalisation que j'avais entreprise.
Recommended Products