Your cart is empty.
Your cart is empty.Omix proudly offers a vast collection of OE quality replacement parts for Jeep & Willys vehicles to help keep the Jeep legend alive. This rear leaf spring shim fits 76-86 CJ and 87-95 Wrangler YJ models. This shim is used to correct pinion angle issues on vehicles with lifted suspensions. Shim measures 2.5-inches wide, 4.75-inches in length and 0.75-inches tall. For 8 degree shims, use 18206.02
Jim OBrien
2025-08-28 15:07:20
Gave me the angle that’s works great. I do recommend them
Tom A.
2025-08-24 18:09:02
After a bunch of modifications, my lifted YJ got a slight vibration going down the road. I calculated 7 degrees to get my transfer case, driveshaft, and pinion angle sorted out. So I went with the 8 degree shim and pointed my pinion up towards my transfer case (I switched to a double cardan SYE kit). Huge difference! The vibration is completely gone.
Lucas C.
2025-08-14 14:15:50
This was perfect for my 95 Yj. I lifted it four inches and the driveshaft was at a bad angle and would vibrate the rear end. Once these were installed it lined up the drive shaft very straight and rode smooth! I just wish it came with new bolts!
Charliex
2025-07-08 17:26:07
I installed this shims to my 6†lift truck
buyer
2025-07-07 17:42:54
Well made, rough finish aluminum to prevent slipping, and curved for spring curve. I had to drill the hole out to fit my spring bolt, but otherwise, PERFECT!! I needed the six-degree wedge, checked these and found to be an actual six degrees. I will purchase again if needed, and I recommend them to anyone needing a curved wedge to match the springs.
Customer
2025-06-23 18:56:33
Not a true 8° shim. It's actually 9° if it is that important to you that the product matches the description and also not a single face of the actual product is square. Cheap sand cast aluminum which is fine, but the quality control is definitely not there.
Justin R
2025-06-04 15:58:08
These worked for my CJ with YJ spring conversion. Needed more castor after install. These balanced out the angle at stock height.
SUPREME BEARINGS
2025-04-21 10:26:00
fast service
Customer
2025-04-07 15:47:09
Set pinion angle
Luke A. Blakely Zroback
2025-03-22 16:46:51
Works great. Thought it was steel but it is aluminum.
Frank b
2025-02-19 15:25:58
Le produit es très mauvaise qualité. L'aluminium écrase et brise.
Recommended Products
$370.82
$ 99 .00 $99.00
$539.00
$ 99 .00 $99.00
$395.99
$ 99 .00 $99.00
$19.00
$ 9 .99 $9.99