Your cart is empty.
Your cart is empty.The shaft collar can be used for general purposes such as blocking, positioning and fixing of pulleys, as well as for fixing the inner ring of bearings, fixing the shaft end of screw shafts, or in gearbox assemblies, motor bases, machine tools, drive shafts, agricultural implements, medical equipment, and equipment for paper and steel mills, the automotive industry, manufacturing, hobby craft industries, etc.
Dr T
2025-06-25 15:07:36
Once you tighten them down, these collars stay in place very well. We are using them to hold the tail stock of a lathe in place, and as you can imagine, there is a tremendous amount of vibration. Previous solutions have eventually vibrated loose, but this collar seems to be holding very nicely.
Dan Schaner
2025-05-06 13:18:44
The bore was oversized and these would not tighten on a 6mm shaft, even with the screw as tight as I could get it. I ordered 3 packs total, and every single one was like that, about 0.1mm oversized. I ended up drilling and tapping another hole for an M3 set screw to make it work, but most people don't have the luxury or capability of doing that. Don't waste your money on these!
Customer
2025-02-25 15:02:12
Excelente
Scott
2024-12-11 10:36:05
Nice fit and finish. Fits perfectly and does what it’s supposed to do.
Charles Ray
2024-12-04 11:36:23
excellent description and super fast shipping
William K.
2024-11-14 18:22:30
Using these on a router sled's motion rails. 2 out of 4 fit perfectly. The other 2 are too tight to fit on the 20mm rail. Fit and finish is good, but the allowable tolerances are crap.
Recommended Products
