Your cart is empty.
Your cart is empty.Art
2025-09-02 13:49:21
Replaced the original lamps in a Fisher tuner - these really work well and light up the dial way better than the original lamps. Not much else to say - they fit fine and work well.
Midwest
2025-08-28 12:25:49
I still own the receiver I purchased when I was in high school. I took it apart to give it a tune up. Even though all the bulbs still worked, I decided to replace them before putting the unit back together.Initially I replaced one bulb for the dial so I could compare it to the original incandescent bulb. The color is identical, just slightly brighter. These bulbs fit the socket just like the original ones.These bulbs have a built-in rectifier which is great because the bulbs for the radio dial are powered by AC voltage. The bulb for the signal meter is powered by DC voltage. If it weren't for the rectifier, you would see the 60 hz flicker from the bulbs for the radio dial.I am very pleased with my purchase.
S. Kirksey
2025-08-14 11:58:30
I used these to replace the fuse lamps in my old Sony STR 6036A stereo amplifier. The originals were old-school filament lamps, half of which had burned out over the last 50 years; the rest were considerably dimmer. The replacement was slowed down by the fact that these LED lamps were about 1-2 mm longer than the originals and I had to finagle them into the holders. Other than that, they worked great - the display is bright and easily legible across my office.
Mr2
2025-07-27 11:07:44
Put these in my 1970s HK 630 twin power and they look just right behind the green display. You may have to squeeze your lamp holders gently for a good connection as in my case the original fuse lamps were a little bigger dia but its a easy adjustment.
Wayne M
2025-07-25 11:53:33
I bought the blue lamps and did not like the appearance. Bought the warm white and they matched the original display lamps.The lamps are just a little bit longer but fit the holder.The installer will need to watch the installation to make sure that the lamp is orientated properly.
ER guy
2025-07-11 10:14:16
Replaced the dial lights and meter light for the Marantz and works well. The old light bulbs is using the AC around 7V to power the fuse type light bulb, this LED has built-in rectifier so just pop it in. Only thing is the LED light bulb has no backing, basically is a strip circuit board with 3 LED lights with metal caps on each side. So I was very careful when I installed those lights.Also I wish the manufacture will have more choice of how many light bulbs in the package. There are 5 bulbs in the package, but most receivers will need more 5 if you replace all of them. So I have to buy 2 packages for my need of 6.Still give it a Five stars even with above concerns. Just hope the maker will continue improve its quality.
Brandon Hayes
2025-07-02 11:14:30
I ordered these because I am servicing a Realistic STA-80 reciever for my brother and all of the original bulbs were dead. You get 5 lights per pack which is fine I had to order two packs since there are a total of 6 in this model. Shipping was a little delayed for some reason and was split into 2 deliveries so I gotta wait until tomorrow to put the last light in. Prices are very reasonable and lights turned out to be super bright very excellent! The first 4 went in find but the two on the right for the signal meters needed to bend some metal clips a bit to get them to fit in the slot because they are slightly longer.Overall I would 10/10 recommend!
Dave
2025-06-28 12:06:29
These bulbs did not fit in my Sansui receiver. They are 2mm longer than the original, and wouldn’t fit in holders properly.
Art
2025-06-05 18:36:36
Replaced the original lamps in a Fisher tuner - these really work well and light up the dial way better than the original lamps. Not much else to say - they fit fine and work well.
Midwest
2025-04-03 18:20:02
I still own the receiver I purchased when I was in high school. I took it apart to give it a tune up. Even though all the bulbs still worked, I decided to replace them before putting the unit back together.Initially I replaced one bulb for the dial so I could compare it to the original incandescent bulb. The color is identical, just slightly brighter. These bulbs fit the socket just like the original ones.These bulbs have a built-in rectifier which is great because the bulbs for the radio dial are powered by AC voltage. The bulb for the signal meter is powered by DC voltage. If it weren't for the rectifier, you would see the 60 hz flicker from the bulbs for the radio dial.I am very pleased with my purchase.
S. Kirksey
2025-03-25 13:02:35
I used these to replace the fuse lamps in my old Sony STR 6036A stereo amplifier. The originals were old-school filament lamps, half of which had burned out over the last 50 years; the rest were considerably dimmer. The replacement was slowed down by the fact that these LED lamps were about 1-2 mm longer than the originals and I had to finagle them into the holders. Other than that, they worked great - the display is bright and easily legible across my office.
Mr2
2025-03-19 21:04:11
Put these in my 1970s HK 630 twin power and they look just right behind the green display. You may have to squeeze your lamp holders gently for a good connection as in my case the original fuse lamps were a little bigger dia but its a easy adjustment.
Wayne M
2025-02-06 11:36:20
I bought the blue lamps and did not like the appearance. Bought the warm white and they matched the original display lamps.The lamps are just a little bit longer but fit the holder.The installer will need to watch the installation to make sure that the lamp is orientated properly.
ER guy
2025-02-01 18:18:28
Replaced the dial lights and meter light for the Marantz and works well. The old light bulbs is using the AC around 7V to power the fuse type light bulb, this LED has built-in rectifier so just pop it in. Only thing is the LED light bulb has no backing, basically is a strip circuit board with 3 LED lights with metal caps on each side. So I was very careful when I installed those lights.Also I wish the manufacture will have more choice of how many light bulbs in the package. There are 5 bulbs in the package, but most receivers will need more 5 if you replace all of them. So I have to buy 2 packages for my need of 6.Still give it a Five stars even with above concerns. Just hope the maker will continue improve its quality.
Brandon Hayes
2025-01-30 16:57:23
I ordered these because I am servicing a Realistic STA-80 reciever for my brother and all of the original bulbs were dead. You get 5 lights per pack which is fine I had to order two packs since there are a total of 6 in this model. Shipping was a little delayed for some reason and was split into 2 deliveries so I gotta wait until tomorrow to put the last light in. Prices are very reasonable and lights turned out to be super bright very excellent! The first 4 went in find but the two on the right for the signal meters needed to bend some metal clips a bit to get them to fit in the slot because they are slightly longer.Overall I would 10/10 recommend!
Dave
2025-01-22 15:29:40
These bulbs did not fit in my Sansui receiver. They are 2mm longer than the original, and wouldn’t fit in holders properly.
Recommended Products
