Your cart is empty.
Your cart is empty.L-pads adjust the relative volume of drivers connected to them by placing added resistance in series and parallel, keeping impedance a constant 8 ohm load. This L-pad is rated at 50 watts RMS, is designed to be used with 8 ohm loads, features a 3/8" shaft length, and comes with mounting hardware.
Customer
2025-08-23 15:09:54
Works well and seems to be constructed well. I am using this as an independent volume control on a monitor system for a Firehouse radio. The max power is 18 watts from the radio, which is less than 1/2 of the L-PAD's rating, so I can't say I am pushing it, but it definitely handles that power well. Since this is almost a set it and forget it application I don't see having any problems with the device from wear, and since the radio has a low duty cycle of output audio, only getting relatively short transmissions periodically, I am not worried about heat either. So all in all this seems like the perfect device for me. Hopefully for those who use it more strenuously will have similar experiences with it.
fishpotpete
2025-08-07 09:02:06
the only downside (and a small one) is that the actual travel to attenuate to silence and back to full volume seems to be about 1/3 turn. But if you know that, then it's not an issue. No heat build up that I have noticed yet. Very easy to install.
Ted Batemon
2025-08-06 13:54:19
Worked as it should very happy customer
najrellim
2025-06-16 17:50:07
This is a "Pass/Fail" review because the attenuator either works or it doesn't. It works well and is well made. I appreciate the enclosed wiring diagram! This product passes the test! I would definitely buy another one or any other product from this company.
Scott Wilds
2025-04-25 11:16:17
Needed to turn the volume down on one speaker in a PA setup, it was too near a mic and causing some echoing. Easy to install and did the job. I used the box to make a housing....
Darth Vader
2025-03-14 16:25:30
Using this along with a 15w tube amp, no issues so far.
Run
2025-03-05 14:03:13
Functions as expected. I use the PE L-Pads on a variety of projects
Mike
2025-01-12 10:24:29
Using these to attenuate horn tweeters . Perfect !
Humberto López rodriguez
2024-12-26 10:04:17
Lo use como pieza de cambio
Recommended Products