Your cart is empty.
Your cart is empty.Product Description
COMPATIBILIITY
- Compatible with 2009-2014 Ford F150.
- Note: ONLY Compatible with Factory Halogen Headlight Models.
- NOT Compatible with Factory Xenon HID Projector Headlight Models.
HIGH SEALING PERFORMANCE
GOOD SEALING STRUCTURE EFFECTIVELY PREVENTS INFILTRATION OF RAIN,SNOW,SAND,DUST, ETC.
EASY INSTALLATION
PRODUCED UNDER STRICT QUALITY CONTROL STANDARDS, EASY PRODUCT INSTALLATION.
ANTI-UV COAT PROTECTION
THE SURFACE INCREASES ANTI-ULTRAVIOLET COAT, EFFECTIVELY PREVENT YELLOWING AND AGING, EXTEND LAMPS LIFE , MAKE VEHICLE NEW FOR A LONG TIME.
HIGH BRIGHTNESS
MAKES THE ONCOMING CARS OR PASSERSBY QUICKLY NOTICE YOU AT NIGHT, ENSURING YOUR DRIVING SAFETY AND OTHERS.
Roaming Engineer
2025-08-14 10:56:58
Everything went in pretty easily on 2009 F150 XLT. Lines up perfect. Looks like new. Things to note with regard to the metal retaining clips on the back of the assembly (no instructions):1. Pry out the plastic rivets holding the rubber sheet in place around the inside of the old headlights and behind the ends of the bumper. Remove the 3 - 10mm bolts holding each headlight assembly in place. Wiggle/pry the old assemblies out and remove all the bulbs. The retaining clips bite onto the plastic alignment pegs on the back. Make sure you remove the original retaining clips left in the the slots in the sheet metal or things won't line up right during reassembly.2. Remove the clips from the back of the new light assemblies, pre-install them in the slots and carefully orient the rectangular plastic pegs with the rectangular slots in the pre-installed clips (slip them into the slots in the body the easy way and rotate them 90 degrees). They can't go in otherwise and quickly get bent out of shape.3. If you try to remove the installed assembly you might mess up the retaining clips so its a good idea to replace all the bulbs with LED at the same time (Costs about $75 less coupons and are way brighter and run way cooler than the factory incandescent bulbs! One of the marker lights came loose in the old assembly and melted a big hole in the plastic.):- Headlights - https://www.amazon.com/dp/B0CNKJVFLC?psc=1&ref=ppx_yo2ov_dt_b_product_details- Amber Turn Signals - https://www.amazon.com/dp/B06WD7Z4R7?psc=1&ref=ppx_yo2ov_dt_b_product_details- Side Marker Lights - https://www.amazon.com/dp/B0B2NMNTHL?psc=1&ref=ppx_yo2ov_dt_b_product_details- Fog Lights (if equipped) - https://www.amazon.com/dp/B077SGQKQQ?psc=1&ref=ppx_yo2ov_dt_b_product_detailsA small flashlight (and X-ray vision) allows you to observe the pins engaging the staples in step 2.Good Luck!
Marc Underwood
2025-08-09 16:45:38
After installing lights , they added a more modern look to the truck as well as incredible luminous rays of lights.
TS
2025-07-19 15:45:18
I bought these in May. There are no instructions at all on installation. I was finally able to figure them out. The marker light does not work the same as the factory one does. I now have one of the assemblies that is leaking and has moisture in it and that has caused my bulb to burn out. Not worth the money. Would not buy again.
mels
2025-07-08 09:50:32
The media could not be loaded.
Beanbagger68
2025-06-10 12:43:09
Arrived almost 3 days early and we're exactly what I ordered. They match my black after market grill to a t.Just one down side the adjuster is very hard to get at screw should be on top not behind ford doesn't give ya much room to get back there.Awsome awsome awsome!!!Simple to install took me 15 min for both sides..
Customer
2025-04-29 10:45:27
My headlight assemblies arrived on time with perfect packaging, I had one assembly that had a minor defect. Contacted customer support and they took care of everything! Easiest process I’ve ever had. They sent me a whole new set and it arrived the next day. Couldn’t be happier with this company!
Joe C
2025-03-22 18:56:31
2010 F150 XLT install. These installed super easily, but....1. The DRL require extra wiring and no instructions were included. This is not plug and play as advertised. Note: the truck had the headlights working as DRL before. Why wasn't this just wired in to work with the circuits already functioning out of the main head lamp connector? Bad design.2. Turn signals didn't work(not a bulb- built in LEDs). Waiting on a new LED rated relay for those to see if that's the issue (another external purchase requirement- not so plug and play). If that doesn't work...On a side note: Stating that professional installation is recommended on an Amazon purchase part is a cop out by the seller. Sellers should provide instructions when items require something other than plug and play.
Letha Parr
2025-03-09 14:50:32
I ordered these for my truck. And they were easy to put in, it was just interlocking. The different mechanisms made a huge difference in my sight at night, so the function of them is great and the durability so far, it's awesome, and I love the look of them, and they're very bright.
Johanne B.
2025-02-19 10:00:34
SUPER pour Ford RAPTOR 2011. Ampoules dels achetées séparément.
Recommended Products