Your cart is empty.
Your cart is empty.Product Description
Konstantin Adamsky
2025-09-03 14:56:25
Great product. Easy to install, looks great and very usefull
KFarg
2025-06-01 18:22:39
Great to get my sons snowboard and skate boards off the garagefloor. Independent pieces you can adjust as needed. No need to to stack all 3 sets together or at the same width.
Elyssa Hamilton
2025-04-22 16:27:46
Perfect for us.
Customer
2025-04-19 18:54:29
The material is a cheap plastic and the screws don't work with the anchors that are provided. Made unnecessary holes in my wall installing these. I don't trust the rack to stand the test of time.
Just some guy
2025-03-11 12:22:59
For the most part, yes, it is easy to install. You drill a hole for the anchor and then you line up the holes with the slots on the rack and then just screw it in. The issue that I ran into was that I was trying to use a drill to screw the screws in, which I think is not that unreasonable. But the angle that I had to come in from to get the drill to screw the screw in was kind of ridiculous.I think next time I will try using a smaller screw driver instead of the drill. I also broke 2 anchors in half when putting them in, this might have been just user error. I might have tried hitting them a little too hard before they were fully in the hole. Luckily I had a few extra ones for a different project that ended up working out quite well.For the most part, it is as sturdy as a piece of plastic would be. It is currently holding up my snowboard, and the lower one is holding up a set of Skis. I think as long as you are gentle about placing your gear on it, you shouldn't have a problem. However I would definitely avoid just nonchalantly throwing your gear onto it.I did like the customizing of it. Since the area where I was going to be putting them already has a lot of stuff in it, I had to get creative with the how I was orienting them. So they were not all attached like in the product pictures. By doing this it allowed me to be a little more intentional with the how I wanted the gear to rest on the brackets.
Ryan Miller
2025-02-21 18:32:55
Sturdy
Customer
2025-01-21 10:54:43
It won't fit with bindings. WAY TOO Expensive for such a cheap quality product
Aaron H
2024-12-31 20:07:09
If you buy multiple and hook them together, it’s too close for snowboards with bindings. Would be good without bindings or any other kind of board. The screw hillmans they provide are garbage. Get new ones or just find a stud. Much better off finding a stud. They’re pretty cheap plastic but do the job. For $20 you can’t argue much
Recommended Products