Your cart is empty.
Your cart is empty.Steel Shim is made from a full hard, cold rolled, low carbon 1008-1010 steel. Precision Brand® is the only manufacturer to offer Branded® shim. It has everything the user needs to know clearly marked right on the shim: material type, material thickness, and lot # for full traceability. Used in applications where hardness, flatness and accuracy are required. Material can be punched or sheared with minimum burring and distortion. Precision Brand® Shim Stock is widely used in the following applications: tool and die set up; alignment; new machine assembly; machine repair and maintenance; mounting of motors, pumps and other machines; short run and prototype work; along with a variety of other industrial uses. It is especially useful for pilot production runs where material accuracy and economy are important. All Precision Brand® shim products are manufactured under rigorous quality control standards to assure high accuracy and tight tolerances.
Michael E. Shake
2025-06-25 15:02:17
First let me say the product is .005 x 6" x 100". It's low carbon steel.I will be using this to make corrugated metal roofing panels for birdhouses. I cut it 2.75" wide by 6" and use a toothpaste roller I found on Amazon to put the corrugations in it. It works good and should work out for me. It's an affordable way to make my panels at just .35 cents per panel.
Greg Cosner
2025-06-06 11:23:41
Very good product. Used to make axle shims.
Harry Brackett
2025-05-09 11:53:55
I used this as trim around a ceiling fan that did not fit vaulted ceiling
Mustang
2025-05-05 17:23:41
Delivered as described.
Ray
2025-05-03 15:17:32
It was as advertised.. Came fast.
Randy
2025-04-24 16:20:23
Good quality.
Ronald S.
2025-04-17 15:10:35
Used this brand in shops for decades, bought this for home project, high quality
Active Shooter
2025-02-23 17:37:32
.005" steel shim stock.Works perfectly for a number of applications. For me it induces turbulent flow in a heat exchanger.
Pierre Theberge
2025-01-21 10:56:39
Great to work with
Pat Glynn
2025-01-17 15:07:36
Made a compressor head gasket.Cut with heavy scissors and gasket hole punch for bolt holes.Good for another 30 years.
Recommended Products
