Your cart is empty.
Your cart is empty.Stabilizer with Suspended Rod Technology in a polymer gel. (6) 1 oz. removable weights.
Cordell R
2025-08-01 10:39:03
It is a bit higher profile slider but if you are able to twist knocks it shouldn’t be a problem.This is much better quality plastic than the previous two I had.
Jesse C. Benton
2025-07-12 09:21:38
My kid lost his when adjusting the bow, and this replacement works great.
Rusty79
2025-07-04 11:55:54
Fits 3/8" rod and glides nicely and I think the black looks better compared to the red.I have an older 90's Black Bear Mag compound bow with the steel wrapped cables. I built a cable guard rod from 5/16" steel rod (big box store for about $4) and then slid about 6" of 3/8 OD 5/16 ID chrome metal tube onto it that I found in the plumbing section and it was bent up a little bit so I got a discount ($2). I bent the rod to make an offset and put some black electric tape on most of the chrome tube except about 2" where the slide would go. I also threaded 5/16-24 with my die (found on eBay for $3) and added a 5/16-24 nut ($1) to lock the rod in place. This definitely and greatly reduced the twang noise from when the cables hit each other.
Billyray
2025-06-18 16:24:36
Slips right on, installs in two seconds.I believe these are way overpriced though.Should be half the price for this small plastic item.
Chad vanderkooi
2025-06-04 12:05:02
I have multiple bows and tried on all off them did not fit properly . Will not slide on 3/8 guide rod carbon or aluminum. Junk!!
Leach
2025-05-08 12:49:28
Works well, nice and smooth.
Brandon
2025-04-30 18:38:21
perfect, as described.
Vlad Khavin
2025-02-18 16:10:31
It does the job and I've had no problems with it, installation-wise or operationally.
Recommended Products
