Your cart is empty.
Your cart is empty.pressure switch is factory set to 95-125. Switch comes with unloader and on/off SWITCH. 1/4" female NPT connection
Cook
2025-09-01 18:11:14
Two years ago, my old Craftsmen compressor needed a new pressure valve. I bought a Hubbell 69JF7LY, which failed just recently. This switch replaced the Hubbell directly, worked perfectly out of the box, and I hope will provide 30 years of service like the original instead of the 2 years service that the Hubbell replacement did. In all visible aspects, this switch seems to be of equivalent quality to the Hubbell. In fact, I like the on-off switch with a nice red lever better than the almost invisible black lever on the Hubbell. Only time will tell if this switch will last longer.
Chris Sack
2025-08-03 13:16:44
I installed this pressure switch on my compressor, and it is working great.
Keystone Kid
2025-07-07 19:18:04
This switch was a perfect replacement for my old Sanborn 2HP 22 gallon compressor with model number 104CB200-22 (Commercial model) same as 104B200-22 model. Old switch was a Furnas #034-0038 Switch only uses two wires (hot & neutral) from the electric motor. Line from air pressure pump to pressure switch unloader, fit exactly without need for modification. I highly recommend this pressure switch and vendor.
Tony
2025-06-24 16:15:34
Good inexpensive replacement pressure switch for my old craftsman air compressor. Works as the old one did and easy to install. The only thing I did not like is how the electrical wire is held in place, the old one had a screw in clamp to lock the wire in place but this one has a rubber grommet that hols the wire in place but unfortunately the wire slowly slides out so I had to add a clamp to hold it in place. If it wasn't for the wire attachment I would have given it a five star.
Veronica
2025-05-08 09:14:46
The unit was as described. Quality built and met every need. Supplier put it in the mail almost as soon as ordered. USPS got it hung up in Texas for 4 days or I would have had it in 2 Days. Would recommend it to anyone who needs this.
Sprucegreen14
2025-04-24 15:23:28
Hard to adjust
DNL
2025-04-13 13:36:31
About as close a direct replacement as you could expect, replaced an old Craftsman compressor switch and it fit perfectly. Only had to route the wires differently which was not a problem. The pressure switch was set perfect right out of the box. Ordered and got it in one day using Prime.
Gregg L
2025-01-12 18:03:27
I am not sure if you can get it with a male end. So i added a 1 inch nipple to connect it to the compressr
Customer
2024-12-04 12:09:07
You may need a 5/16†adaptor to screw into the unit.
Recommended Products
