Your cart is empty.
Your cart is empty.
Specification:
Item Type: Manual Pressure Test Pump
Maximum Testing Pressure: 1000PSI / 7MPa
Instructions:
1. Install the machine and secure the pump body to the water with four screws.
2. Install the water pipe and connect it to the pump body (Note: seal connection, add washer, you can also use PTFE tape, otherwise it is easy to leak)
3. Connect the other end of the outlet hose to the tested pipe
4. Fill the test tube with water, vent the air, and then close the pressure relief valve.
5. Fill the water with water, then rock the handle up and down to start the pressure test.
6. When the pressure gauge rises to the required pressure, the pressure can be stopped (normal tap water pressure is 0.3Mpa, high-rise residential building water pressure is 0.4Mpa, water pipe pressure test is generally pressurized to 0.8-1Mpa, 0.1Mpa is equivalent to 1kg pressure)
7. After stopping the back pressure, if the indicated pressure does not drop, it can be proved that the pressure of the pipe is good. On the contrary, it can be proved that the sealing performance of the sealed tube was not good, and there exists a leakage that has caused a pressure drop.
Package List:
1 x Pump
1 x Handle
1 x Water Pipe
9 x Seal Ring
1 x User Manual
Ideation Mechanical
2025-07-01 16:03:31
Considering the price, I had low expectations. But if they simply assembled it correctly it could work well. The connection from the pump is basically an NPT fitting attempted to be sealed with an o-ring but certainly not using ORB or ORFS fittings. The o-ring was split and sticking out of the threads, where of course water squirts out as soon as you start pumping.The hose that comes with it is basically a 1/4" garden hose, "sealed" with an o-ring on the face of your fittings. It comes with a little bag of o-rings/gaskets but you might as well just buy actual fittings and a better hose from the start. I went to disassemble it to fix the main broken seal but everything feels like it'll break as soon as it starts to turn. I'm going to finish my current testing needs with it leaking to get the job done first before I accidentally ruin this thing.Prepping a test fixture, I assembled it with with quick connect fittings, a separate pressure gauge and ball valves. I basically pump quickly to get the pressure up where I want it and try to close the ball valve before the pressure leaks out. It's getting the job done but this is VERY POOR. It can work up to maybe 350 psi but getting anything more than that out of this is probably pushing your luck. Adjust your expectations accordingly.
Jose
2025-06-27 14:07:49
Lo recomiendo
christian garcia
2025-06-14 13:34:07
El sistema para bombear el agua no es de buena calidad, funciona pero parece que está dañado. Creo que sà corrigen eso serÃa un buen instrumento
Xin Tong
2025-05-29 11:45:36
When i got it, its pressure gauge glass crack, i think it is not afffect my use, but fist time try to pump up hydro liquid to my car. it does not holding pressure.
Manuel B. Preciado Olaiz
2025-01-26 18:20:47
Me falto el adpatador que dice que incluye y estoy batallando para encontrarlo DIÃMETRO EXTERIOR 1/2", DIÃMETRO INTERIOR 1/4".
Recommended Products
$174.99
$ 86 .99 $86.99
$81.95
$ 37 .99 $37.99
$74.71
$ 33 .99 $33.99