Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
Adrian7257
2025-06-05 18:46:38
Its far more durable an rigid than i thought it would be.I took it off after a few weeks because the vibration was too much butFor racing application..this is the best mount for ur money.. excellent stability from back-torque and downshifting! 👌
Ashley Campbell
2025-05-20 16:15:51
After looking at a posting in the Nissan Owners forum, I was expecting to be able to press out the existing rubber insert and replace it with the Prothane insert; similar process for fitting the 14-502 right engine mount. For my Australian model, the 14-502 mount would have proved to be the right size insert. I ended up cutting out the existing rubber mount fitting thus re-using the metal retaining ring to get a perfect fit.I definitely needed to pack out the centre metal tube insert with spring washers for the transmission mount to prevent excessive chassis vibration. At this stage I have not yet fitted the rear engine mount insert because it does not need replacing and I do not want any extra chassis vibration.Note: This is a solid mount so you do have to expect a bit more vibration than the standard rubber mounts.
JR
2025-05-10 15:21:07
front and rear torque mounts on 99 G20. keep the metal shell and these work well.
gonzalez4470
2025-02-09 12:09:17
GOOD BUSHING I HAD IT MACHINED DOWN THEN INSTALL IT IN A MOTOR MOUNT FOR A 98 ALTIMA
Donovan P. Brown
2025-01-27 11:23:42
Great mount, if you are buying this for a 96 200sx SE-R like i did make sure that you have the original motor mount bracket. Doesn't fit the aftermarket one. I used window weld 3M (polyurethane) to fill the voids.
Danny Castro Arias
2024-12-24 14:32:37
Excellent
Recommended Products
$33.70
$ 14 .99 $14.99