Your cart is empty.
Your cart is empty. * Durable Urethane and Metal Construction
* For Street or Competition Use
* Hardware Included
* Made in USA
ROB
2025-08-14 14:03:53
These mounts fit perfect in my 1988 mustang GT. No modifications were necessary but it took a little finesse to get them in due to limited space. My original mounts were pretty much spent and i was getting some vibration so i got these. Very smooth with no vibration like factory rubber mounts but will last a lifetime. They are very strong and built like a tank. I also have used prothane on other cars with excellent results.
rc
2025-08-12 10:39:45
Fit well on a 1993 Fox Mustang 5.0L motor as it should.
Trent R
2025-05-24 13:18:12
As close to solid as you can get and I don’t notice any engine vibrations even after replacing 30 year old almost non existent mounts.
JamesPNW
2025-02-26 16:22:19
I bought a parts store replacement set... They didn't even bolt up to the block I spent an hour fitting them and they where terrible engine flopped around under load. Bought these and the fit perfectly engine is snugly held into place .
Always in the Woods
2025-02-17 21:29:30
Don't bother with parts store replacements. these are quality made, fit perfect, and perform great. They'll also last you almost forever.
Jon Cantin
2025-01-21 18:43:36
These are well made motor mounts.
MMC CLUTCHES
2025-01-14 16:30:13
I liked the design and fitment of this product but upon installation stud came out. Did not snap just pulled out looks pressed in not welded in very poor quality unless i just got a defect
Customer
2024-12-03 14:03:26
Cant go wrong with something that's fits perfectly while looking clean
Recommended Products
