Your cart is empty.
Your cart is empty.Antonio
August 28, 2025
Really happy with the way this product looks and feels have not fired the motor that these went into but they look like they will work good. The only thing that I am not happy about is that there is nothing printed on them like the picture shows.
Jean K.
August 18, 2025
The pushrods appear to be well made but like other reviewers I too have an issue. The pushrods have some debris inside the tube. I soaked them some solvent but still had to run some wire through all of them to remove the gunk or whatever was inside the tube. Once I did the cleaning the pushrods were nice and shiny inside and ready to install. I haven’t installed them yet but hopefully the pushrods will perform well for a long time
J.M. Hughes
July 29, 2025
Always check your parts before installing. The set I got had a piece of metal lodged in it that was so big it would not flush out had to push it out with wire, made an audible “tink†when dropped onto the workbench. Several others also had smaller pieces of metal as will as very fine shavings. Double check and clean your parts. I can’t tell you how will they perform as the motor has not been started yet. After seeing a review about them being a bit long I wish that I had them measured but don’t have the tool
Customer
July 28, 2025
installed these like a fool without measuring. could not get the engine to run correctly.shortest pushrod was 7.402" with the longest at 7.414"galled lifter faces and galling on the long lifter heads.Waste of money and a huge waste of my time. I purchase Melling and measured all OK.Not one of these were within GM LS specification.
Steven Heiser
July 7, 2025
My set were full of mental shavings inside the center . Took a while to remove
benlee
May 25, 2025
junk tips
Bobby Hanvey
May 23, 2025
No problems
Preston Andel
May 9, 2025
2005 Chevy Silverado 1500 Ext. Cab 5.3L L33. Running so far. Put them in when we upgraded my truck to a stage 2 cam. Nothing wrong so far. The holes through the rods are slightly bigger, so my oil pressure is slightly less than before because of more oil flow. Nothing wrong with that. Working as intended.
Dean Y
March 17, 2025
Pushrods were as described and delivered on time
Bob
January 26, 2025
Pushrods were bent from new.Make sure to check them before installation
Recommended Products
$79.37
$ 35 .99 $35.99
$45.00
$ 21 .99 $21.99
$126.99
$ 52 .99 $52.99