Your cart is empty.
Your cart is empty.Customer
2025-09-01 09:27:14
Overall it's exactly the look we were going for. The adhesion doesn't work on the curved surface so we added zip ties on the ends. Doesn't interfere with the lights and you can't tell unless you know they're there. The wires are extremely tiny so it was a little difficult to hook up. Very bright and visible. The front blinkers are really neat because they have a cascade affect. The back blinkers just blink normally. Would have been nice if they matched. Still recommend this product. 5 stars.
HeatherMed
2025-07-29 18:36:05
It worked just fibe on my bike and was easy to install. No issues.
peter y.
2025-07-28 12:57:38
Only reason I'm giving it 3 stars rather than 5 is because of the adhesive. Make sure you have something flat to put this thing on. Or get some kind of adhesive yourself to keep this in place of using on a motorcycle. For the price it's good money it's easy to wire. It's just a matter of keep it in place. It would be nice if it had a thicker adhesive on the back or something you can buy like a plate.
Wondering Traveler
2025-07-12 17:57:28
Good.Bright, and easy to mount. Simple 3 wire setup.Bad.Wires are extremely thin. making it difficult to splice or solder to other wires.
Sean Long
2025-01-23 16:28:09
Mounted on the forks and ft ram3 gives bike a sleeker look and enhanced visibility to other drivers. Highly recommend this product
Nick
2024-12-31 15:25:38
I was initially impressed with these LED brake lights and turn signals—nice and bright when tested, and they seemed to work perfectly. However, despite being marketed as “flexible,†the quality of the circuit board leaves much to be desired. The LEDs are mounted on an extremely thin foil-like circuit, which cracked and broke during installation on my bike. Even normal handling caused damage. Unfortunately, these lights are not durable enough for practical use. I wouldn’t recommend spending your money on these—very disappointing.
Nathaniel Ashton
2024-12-22 16:23:20
The media could not be loaded.
Robert B.
2024-12-04 14:23:00
I used one of these lights to illuminate the rear license plate on my '03 Aprilia motorcycle. Connected the black and red wires to a keyed source, peeled off the covering for the 3M double-sided tape, stuck it under the tail light, and it works great. Out of curiosity, I connected the yellow wire to see how the turn signal function worked, and it's bright as well (every other LED is yellow). Since I didn't use this as a turn signal, I didn't permanently connect the yellow wire, but they work and they're bright.
Recommended Products