Your cart is empty.
Your cart is empty. Note: The color of the item may vary slightly due to photography and your own computer / Phone
If you are not 100% completely satisfied with our products, please do not hesitate to contact us to request a refund or exchange!
RampCrab +10mm driveshaft extension for Scx24, AX24, FCX24, TRX4M.
Add more than 1 for longer wheelbases. each one adds 10mm length.
Specifications：
Item name: +10mm Drive shaft extenders for AX24, SCX24, FCX24, TRX4M
Included:
Drive shaft extenders (10)
Screws M1.4*5 (10)
Note: Please check your specific model's manual for compatibility, or contact us.
RMM
2025-08-01 16:34:54
This, was actually a complete life saver. Extended a crawler and these did the trick on the shafts.
Customer
2025-07-21 17:09:40
Fit and finish is good. Works as advertised. Really nice to have on hand when building custom rigs and bending your own links. Takes some of the work out of fitting driveshafts.
Kevin
2025-07-06 10:40:23
Great product for custom builds . I wish the hole was D shaped instead of round to match SCX24 or FCX24 transmission output shaft. I used hot glue to fill the void . Worked out great. I also drilled one out larger for use on a larger rear axle pinion shaft . Plenty in the package to last a few projects.
Kristopher d.
2025-06-19 12:36:21
They don't seat tightly on the drive outputs, and make the driveshaft wobbly. Hasn't posed a problem yet, but be forewarned.
Devin A.
2025-05-18 12:39:09
Exactly what I needed!!!
Jitblass
2025-02-07 15:09:27
The media could not be loaded.
Riley
2025-01-26 19:35:39
These work well , just add two layers of heat shrink to the out shaft of transmission, slide the extension over the out shaft, line the screw up to tighten against the flat side of out shaft.. problem solved…. a must for custom builds…
Nathan
2025-01-03 10:51:02
Thought this was just what I needed however it does not mount on to the TRX4m very disappointing since it’s advertised to fit. Seems to be sturdy material just not sized correctly
Bill Shuttleworth
2024-12-26 15:52:04
Great product if your driveshaft is to short by more than 10mm they were slightly to long for one of my projects.
Recommended Products
