Textured Surface

Rear Bumper Protectors feature a thick, textured, and non-slip surface. The stylish, textured surface design allows you to feel safe when setting something onto the bumper of your vehicle without fear of it falling off. Knowing your shoes are gripped to our RBP, you will feel safe stepping onto your bumper, rain or shine.

Easy Installation

Installing a Rear Bumper Protector to your vehicle is a breeze. Clean the surface of your bumper, peel the pre-applied 3M Tape, and stick the RBP on. Every vehicle is different, and some applications may require the RBP to be bent to match the exact curvature of your vehicle. A set of easy-to-follow installation instructions are included with your order.

Protective Barrier Against Damage

Drop a tool? No problem. Pet paws scratching your bumper? No problem. Manufactured using high quality polyurethane, Rear Bumper Protectors provide a layer of defense against damage. Without a RBP, you leave your bumper vulnerable and at risk of receiving scratches, chips, and scuffs. If your bumper already has a few unsightly marks, this RBP is capable of effectively covering up the damage.

Vehicle Fitment Checked!

Our installation staff has factory fitted this Rear Bumper Protector for proper fitment onto specific vehicles, ensuring it will perfectly fit the shape of your bumper.

STEP 1: Clean Bumper

Clean the surface of your bumper with a clean cloth. Then, using the alcohol wipe provided, wipe down the bumper until clean. Let any excess residue dry prior to installation.

PLEASE NOTE: Your vehicle should be at least 75°F for proper installation.

STEP 2: Line Up Arrow With Trunk Latch

To place your bumper protector properly, start by lining up the arrow on the bumper cover with the trunk latch located within the trunk of your vehicle.

PLEASE NOTE: Do not remove tape yet.

STEP 3: Dry Fit

After centering the bumper protector, carefully bend the sides along the curvature of your vehicle's bumper. This step is to ensure that you are happy with the placement before fully installing the bumper protector.

STEP 4: Remove 3M Tape

Remove all tape lining from the underside of the bumper protector. Do not touch tape or place onto a surface other than your bumper.

STEP 5: Place Center Down

Carefully place the center of your bumper protector down. Once again, you will line up the arrow on the bumper protector with the trunk latch. You will want to keep the bumper protector as close to the edge of your bumper as possible.

STEP 6: Bend To Match Bumper Curvature

Placing one side at a time, carefully guide the bumper protector along the curvature of your bumper.

PLEASE NOTE: Do not press down until you are completely happy with fitment. This allows you to pull bumper cover back up if a mistake has been made.

STEP 7: Press Down Firmly

Using a clean cloth, firmly press down on bumper protector.

STEP 8: Finished

You're done! Please allow up to 24 hours before washing your vehicle or traveling through inclement weather.