Your cart is empty.
Your cart is empty.Product Description
Christopher Harper
2025-08-16 15:28:14
I was skeptical about this bar being quality but to my surprise it’s awesome! Heavy duty actually has some weight to it! Much brighter then I though it would be. Easy install and it’s adjustable! Totally changed the look of my RC truck! It’s also a great replacement for the Rlarrlo amd12 light bar!!
raymond
2025-08-11 17:32:27
These are super bright. The fit and finish are much better than the $2 cheaper kind. It's a no brainer to buy these as they have an on and off switch. If you have an extra channel on your radio you can turn them on and off from your radio. I made a mount for this on my rc and it looks like it's a factory light kit. I will only buy these from now on for any other rc's. They hold their position well and are plain and simple a complete upgrade than the other lights of this size. Go ahead and get em they work great and are an amazing value.
smiley37greg
2025-08-04 17:36:37
Very well built, sturdy bracket, long cable. Pretty bright as well.I made a small bracket to mount it on an 1/8th scale ebuggy.Looks awesome cruising the cultasac.
Ricardo
2025-07-12 16:48:28
**UPDATE**The switch itself isn't very good, I just realized there's a physical button that you can press and now it is very bright. Doesn't work if plugged into the receiver and switched, still dim, but at least now I have a working light bar. Company also reached out and gave me a full refund, can't be mad so 4 stars.**ORIGINAL**I must've gotten I dud because the light is super dim. It does strobe when I turn the channel off and then completely off when I switch it on and off again. It's just too dim to work well so that sucks. Other buyers seem to have a good brightness so purchase with caution/low expectations, 1 star.
Kim
2025-07-03 10:48:00
Update 2: 6v is perfect and does not heat up nearly as much.Update: Be very careful where you mount these. They got very hot even to the touch over time. It takes a minimum of 10 minutes but does continue to get hotter. Its to be expected with the output but it will soften PLA 3D printed parts at 7.4V. Its rated for that and higher but the manual does says optimal is 6.0V. I was worried about the wires getting warm but after 20 minutes, it was only the metal on the lightbar itself.Put two of the smaller light bars on top of my Cross NT6 and it's incredible. Extremely Bright. Even with the vertical mounts in the roof rack, it still lights up everything in front of it. I did not use the included controller, it was fine but preferred a simple on and off. The included controller does on, breathing and strobe. Mounts are metal, rear fins are metal and it even has a see thru piece in front of the LEDs. I assume they will draw some voltage but being on a crawler and LED I am not too worried. Hopefully I can update after a few runs. Very happy with these. Looking forward to adding more to my other rigs.
Sam
2025-06-25 17:05:22
The media could not be loaded.
Charles farris
2025-06-10 11:17:57
Very bright easy to install!
ebarks
2025-05-15 15:46:17
High quality construction, super bright and a module for switching between fast strobe, slow strobe or just on. Automatically starts off when you plug it in to the car too, so you can’t accidentally leave it on.
Martin Gagnon
2025-02-14 16:15:43
Éclairage incroyable.Vraiment très efficace.
sam dahmer
2025-02-03 19:22:38
on off switch didn’t seem to work, had to cut the wires off of the switch and jus wire it straight to my receiver to the light…
Recommended Products