Shopping Cart

Your cart is empty.

Your cart is empty.

RED WOLF 12V 250A Power Distibution Block 5/16' Single Stud Busbar M8 Terminal Bus Bar 12 Volt DC Battery Junction Post for Auto Boat Marine Solar System Positive and Negative (2PC)

Free shipping on orders over $29.99

$12.88

$ 5 .99 $5.99

In Stock

1.Size:Single M8 Stud


About this item

  • Power Busbar Specification: Stud Size: 5/16" (M8) single stud for large terminal connector and wire; Max Continuous Amperage: 250A (in a DC 12V circuit); Max Voltage: DC 48V (when rated 62A)
  • DIY Circuit: Terminal junction box is suitable for customizing battery and wiring setups; It simplify multiple power connections, maintaining a tidy circuit layout and reduce short circuit risks
  • Heavy Duty Construction Made: 12V power distribution block uses 316 stainless steel nuts with pure copper studs as conductors, enabling better corrosion resistance performance and good conductivity; Flame retardant nylon base is used for insulation and safety use; Integrated nuts at stud base for better tightening
  • Wide Application: M8 single terminal block is designed to hold terminals securely in place; Ideal for various vehicles and vessels, including cars, RVs, yachts, caravans, ATVs, and ship power systems
  • Easy to Use: Include a red positive bus bar and a black negative battery junction block; Feature two screws panel for any flat surface install; Allow 360° wire lug installation with no barrier block post; Recessed #10 mounting holes for more aesthetics



Product Description

RED WOLF M8 Single Terminal Block

.

Help customize battery and wiring setups.

Terminal Busbar 12V-48V

.

Heavy duty construction enable better performance.

Single Terminal Bus Bar M8 Stud

.

Helpful to customize battery and wire setups

Details of Battery Junction Block

.

Flame-retardant Base

For insulation and safety use

.

Integrated Nuts

Integrated nut at stud base for better tightening and convenient stud replacement

.

Two Screws Panel Installation

Block post without barrier for freer wire lug installation

.

Pure Copper Stud

For better conductivity


Tom and Gretchen
2025-08-30 16:06:22
I used this when I was wiring up a couple electric fishing reel ports. I ran each hot lead to its own circuit breaker and put the negatives on this community ground. It worked great and was easy to install.
keepShopping101
2025-08-03 17:38:59
I would prefer if the connector had an insulated plastic cap to protect the screws and reduce the risk of short circuits.
Corey
2025-06-05 15:02:48
These studs are strong and well made. Quite a bit stronger than most of the studs I've purchased off of Amazon over the years.These have the backing nut easily accessible so you can use two wrenches to insure a good solid torque.I beat the plastic mounting assembly up pretty hard with my impact driver, and they remained intact and strong. Impressive!
Jonathan D Fielding
2025-05-27 15:33:24
These power studs are not too big and have everything I would expect. The red color though is more of a maroon which I don't care for. Other than that it should work great for power distribution
Zilacon
2025-05-26 16:00:50
These work great for any battery project, I am not sure why they listed it as 12v but it can definitely go higher than that. Its worked fine for me on a 24v battery setup.
Evangogh
2025-02-22 15:23:55
Would be great if it included plastic covers for the studs, but nice heavy plastic with solid terminals.
Wes
2025-01-03 13:28:49
Theses are great insulated distribution blocks, makes joining a few cables easy and secure, just what I needed for my inverter battery project!
Recommended Products